Tensile Fatigue Strength of Synthetic Fiber Ropes
نویسندگان
چکیده
منابع مشابه
RELATIONSHIP OF TENSILE STRENGTH OF STEEL FIBER REINFORCED CONCRETE BASED ON GENETIC PROGRAMMING
Estimating mechanical properties of concrete before designing reinforced concrete structures is among the design requirements. Steel fibers have a considerable effect on the mechanical properties of reinforced concrete, particularly its tensile strength. So far, numerous studies have been done to estimate the relationship between tensile strength of steel fiber reinforced concrete (SFRC) and ot...
متن کاملEFFECTS OF TENSILE STRENGTH ON FATIGUE BEHAVIOR AND NOTCH SENSITIVITY OF TI-6AL-4V
In this research, rotating bending fatigue test at minimum to maximum stress ratio of R=-1 was used for investigating the fatigue behavior of Ti-6Al-4V alloy. Both smooth and notched specimens, with elastic concentration factor, kt, of approximately 3.6 and 4.1 were used for this purpose.In addition, the effect of variation in ultimate tensile strength, UTS, on the fatigue behavior of this allo...
متن کاملEffect of Fiber Misorientation on the Tensile Strength of Compression Molded Continuous Fiber Composites
Resin cross-flow during compression molding of unidirectional sheet molding compound composites, such as CSMC and XMC, may cause severe misorientation of the continuous fibers in the outer layers. The extent of fiber misorientation depends on the type of molding compound, the length of cross-flow, and the location of the charge in the mold. The tensile strength is reduced in the direction of cr...
متن کاملEffects of Fiber Length and Fiber Orientation Distributions on the Tensile Strength of Short-fiber-reinforced Polymers
This paper presents an analytical method considering the effects of fiber length and fiber orientation distributions for predicting the tensile strength (TS) of short-fiber-reinforced polymers (SFRP). Two probability density functions are used for modelling the distributions of fiber length and fiber orientation. The strength of SFRP is derived as a functiolz of fiber length and fiber orientati...
متن کاملTensile and fatigue strength of hydrogen-treated Ti-6Al-4V alloy
Tensile, fatigue and fractographic data on Ti-6AI-4V microstructures attained through a series of post-L3-annealing treatments which used hydrogen as a temporary alloying element are presented. Hydrogen-alloying treatments break up the continuous grain boundary 0c and colony structure, and produce a homogeneous microstructure consisting of refined s-grains in a matrix of discontinuous 13. These...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Japan Institute of Navigation
سال: 1985
ISSN: 0388-7405,2187-3275
DOI: 10.9749/jin.73.151