Tensile Bond Strength between Custom Tray and Elastomeric Impression Material
نویسندگان
چکیده
منابع مشابه
Drying time of tray adhesive for adequate tensile bond strength between polyvinylsiloxane impression and tray resin material
STATEMENT OF PROBLEM Use of custom tray and tray adhesive is clinically recommended for elastomeric impression material. However there is not clear mention of drying time of tray adhesive in achieving appropriate bonding strength of tray material and impression material. PURPOSE This study is to investigate an appropriate drying time of tray adhesives by evaluating tensile bonding strength be...
متن کاملInfluences of differences in tray design and impression material on impression pressure at edentulous mandible.
The aim of this study was to examine the effects of tray design and impression material on impression pressure in a clinical simulation model of an edentulous mandible. Two types of polyvinylsiloxane elastomer, one type of polyether elastomer, and one type of alginate were used. The three tray types had no relief, 0.36 mm of relief, or 1.4 mm of relief, with or without escape holes. Impression ...
متن کاملEvaluation of Tensile Bond Strength between Dentin and Metallic Copings Using Different Resin Cements
Statement of the Problem: For a successful clinical outcome, luting agents should have a high bond strength. Bond failure is still one of the main reasons of restoration failures. Purpose: The present study was designed to comparatively evaluate the retention of metallic copings using different resin luting cements. Materials and Method: In the present experimental study, 40 intact premolar tee...
متن کاملComparison 0f Different Impression Procedures on Tissue Displacement
Background: In bilateral partial edentulous condition modified Mc Lean’s Impression technique is most commonly advised, this over impression procedure may be time consuming clinically and possible errors too can be induced while recording. The purpose of this study was to determine the efficacy ofsingle custom tray using medium body elastomeric impression material overmodified Mc Lean’s impress...
متن کاملFabrication of a Custom Sectional Impression Tray for a Patient with Oral Submucous Fibrosis
Gaining access into the oral cavity of patients with limited mouth opening is difficult and rehabilitation of such patients is a challenge. The loaded impression tray is a bulky item that needs to be placed intraorally. In patients with microstomia, obtaining accurate impression using conventional techniques is difficult due to limited mouth opening and thus alternate clinical procedures need t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Dental Materials Journal
سال: 2007
ISSN: 1881-1361,0287-4547
DOI: 10.4012/dmj.26.323