Tendency of Polyvinylchloride-Coated Steel Sheet
نویسندگان
چکیده
منابع مشابه
Supporting Polyvinylchloride Polymeric Blend Membrane with Coated Woven Fabric
Blend reverse osmosis membranes were fabricated using polyvinyl chloride (PVC) with cellulose acetate (CA) as polymer blends. Tetrahydrofuran (THF) and N-Methyl-2-pyrrolidone (NMP) were used as solvents. The membrane polymer solution was cast on a coated woven fabric support material. The prepared membranes have been characterized by SEM and mechanical properties. SEM r...
متن کاملAnalysis of deformation-induced surface morphologies in steel sheet
The surfaces of strained mild steel sheet specimens were examined with scanning laser confocal microscopy. Rigorous assessments were employed to establish the form of the roughness data. The small deviations from the ideal conditions observed in these assessments indicated that the stochastic process responsible for surface roughening does not conform to stationary, Gaussian, Markov statistics....
متن کاملFailure characteristics of a dual-phase steel sheet
Failure in ductile sheet metal structures is usually caused by one, or a combination of, ductile tensile fractures, ductile shear fractures or localised instability. In this paper the failure characteristics of the high strength steel Docol 600DP are explored. The study includes both experimental and numerical sections. In the experimental sections, the fracture surface of the sheet subjected t...
متن کاملStrength and Toughness of Reinforced Concrete with Coated Steel Fibers
The effect of zinc phosphate (ZP) and zinc calcium phosphate (ZCP) coatings on the reinforcing mechanisms of smooth steel fiber in cementitious matrix have been studied. The results of pull out tests illustrated that by coating smooth steel fiber the pull-out load may be increased up to 100%. The effect of zinc phosphate coating on interface bonding was more than zinc-calcium phosphate coating....
متن کاملOxidation resistance of plasma coated and laser treated mild steel
Stainless steel powder was coated on mild steel substrate using plasma coating. The porous coating thus obtained was modified using laser irradiation. The oxidation behaviour of the plasma coated as well as laser treated material was studied in air at 1073 K. There was considerable decrease in oxidation rate of mild steel after plasma coating as expected. In addition the oxidation resistance im...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1980
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.66.7_882