Temperature effects on DLC coated micro moulds
نویسندگان
چکیده
منابع مشابه
Anti-sticking behavior of DLC-coated silicon micro-molds
Pure carbon(C), nitrogen(N) and titanium(Ti) doped diamond-like carbon (DLC) coatings were deposited on silicon (Si) micro-molds by dc magnetron sputtering deposition to improve the tribological performance of the micro-molds. The coated and uncoated Si molds were used in injection molding for the fabrication of secondary metal-molds, which were used for the replication of micro-fluidic devices...
متن کاملReplication performance of Si-N-DLC-coated Si micro-molds
Micro-hot-embossing is an emerging technology with great potential to form microand nano-scale patterns into polymers with high throughput and low cost. Despite its rapid progress, there are still challenges when this technology is employed, as demolding stress is usually very high due to large friction and adhesive forces induced during the process. Surface forces are dominating parameters in ...
متن کاملSpatially Resolved Strain Measurements on Micro Moulds
The strain distribution in surface treated Toolox 44 steel was investigated using synchrotron Xray diffraction. Surface treatment involved a sequential application of grinding, micro milling and abrasive micro peening processes. The micro-features created at the milled surfaces were studied using a high lateral resolution CCD based Material X-ray Imaging (MAXIM) detector. Results from the strai...
متن کاملHaemocompatibility evaluation of DLC- and SiC-coated surfaces.
Diamond-like carbon (DLC) and silicon carbide (SiC) coatings are attractive because of low friction coefficient, high hardness, chemical inertness and smooth finish, which they provide to biomedical devices. Silicon wafers (Si(waf)) and silicone rubber (Si(rub)) plates were coated using plasma-enhanced chemical vapour deposition (PE-CVD) techniques. This article describes: 1- the characterizati...
متن کاملBiocompatibility evaluation of DLC-coated Si3N4 substrates for biomedical applications
DLC coatings are of enormous interest for biotribological applications due to their biocompatibility, auto-lubricious, and non-stick properties. The most demanding implant is the hip joint. Alternative materials to metal alloys are being increasingly investigated aiming low wear debris volume, in any case innocuous wear particles. Silicon nitride (Si3N4) ceramics are light, tough, mechanical re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Surface and Coatings Technology
سال: 2016
ISSN: 0257-8972
DOI: 10.1016/j.surfcoat.2016.08.034