Temperature control for high pressure processes up to 1400 MPa

Compressed Liquid Densities for Binary Mixtures at Temperatures from 280- 440K at Pressures up to 200 MPa

A method for predicting liquid densities of binary mixtures from heat of vaporization and liquid densityat boiling point temperature (ΔHvap and n b ρ ) as scaling constants, is presented. B2(T) follows a promisingcorresponding-states principle. Calculation of α(T) and b(T), the two other temperature-dependentconstants of the equation of state, are made possible by scaling. As a result ΔHvap and...

Temperature and pressure dependence of the addition reactions of HO to NO and to NO 2 . IV. Saturated laser-induced fluorescence measurements up to 1400 bar

High-Temperature Pressure Transducers

Pressure sensing systems operating at temperatures >200 °C are required for a variety of presentand next-generation applications ranging from oil field instrumentation to turbine engine control. Quite often, part or all of the sensing system must be physically removed from the hightemperature environment. In some cases, pressure translating devices and capillary tubes are used to isolate the se...

Economic-Statistical Design of a Control Chart for High Yield Processes When the Inspection is Imperfect

CCC-r control chart is a monitoring technique for high yield processes. It is based on the analysis of the number of inspected items until observing a specific number of defective items.  One of the assumptions in implementing CCC-r chart that has a significant effect on the design of the control chart is that the inspection is perfect. However, in reality, due to the multiple reasons, the...

Shrinkage and Creep Properties of High-Strength Concrete Up To 120 MPa

Recently, the use of high-strength concrete has become more popular due to the availability and significant variety of the admixtures. High-strength concrete increases the load carrying capacity of the columns, therefore, reduces their sizes in buildings and bridges. In bridges, high-strength concrete could result in reduction of number of girders as well as an increase in the span length which...