Technical Investigation on Drill Pipe Failure
نویسندگان
چکیده
منابع مشابه
Research on Three-point Centering Device of Cylindrical Drill Pipe
In the process of tightening up and screwing off the iron roughneck, it is required that the center of clamping pliers and the center of drill pipe are coincident, so as to avoid the damage of the circular guide in clamping system, and to ensure the iron roughneck work normally. While the traditional method of centering is artificial in iron roughneck, its precision is low, so it is easy to dam...
متن کاملFailure Investigation of Hydrogen Blistering on Low-strength Carbon Steel
The current study assesses the root causes of hydrogen blisters on low strength carbon steel equipment. For this purpose, some experiments including hardness test, non-destructive test (NDT), metallography, and fractograpghy are conducted. The microstructure of two blisters is assessed by means of optical microscopy and scanning electron microscopy (SEM). The microstructural studies show that t...
متن کاملDrill failure during ORIF of the mandible. Complication management.
A case of a drill breakage during open reduction and internal fixation (ORIF) of a mandibular fracture is reported. The clinical decision, diagnosis and surgical management of the complication are described.
متن کاملExperimental Investigation on CuO/Water Nanofluid Effect on the Heat Transfer Rate of Heat Pipe Network
In this study, a new configuration of heat pipes as Heat Pipe Network is introduced. Here, the heat pipe network is designed, constructed and then has been under the performance assessment. This heat pipe network consists of 4 vertical heat pipes connected to evaporator collector from bottom and condenser collector from top. In order to investigate the effect of nanofluids on the thermal effici...
متن کاملInvestigation of Packaged Miniature Heat Pipe for Notebook PC Cooling
Miniature heat pipe (MHP) with woven-wired wick was used to cool the CPU of a notebook PC. The pipe with circular cross-section was pressed and bent for packaging the MHP on the very limited space of a notebook PC. A cross-sectional area of the pipe is reduced about 30% when the MHP with 4mm diameter is pressed to 2mm thickness. In this study, a performance test has been performed in order to r...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Naval Architects and Ocean Engineers
سال: 2017
ISSN: 1880-3717,1881-1760
DOI: 10.2534/jjasnaoe.26.183