Tantalum oxide thin films for electrochemical pH sensor
نویسندگان
چکیده
منابع مشابه
Enhancement of Electrochemical Hot Electron Injection into Electrolyte Solutions at Oxide-Covered Tantalum Electrodes by Thin Platinum Films
The Journal of Physical Chemistry B is published by the American Chemical Society. 1155 Sixteenth Street N.W., Washington, DC 20036 Article Enhancement of Electrochemical Hot Electron Injection into Electrolyte Solutions at Oxide-Covered Tantalum Electrodes by Thin Platinum Films Yung-Eun Sung, and Allen J. Bard J. Phys. Chem. B, 1998, 102 (49), 9806-9811 • DOI: 10.1021/jp982739p Downloaded fro...
متن کاملElectrochemical Characterization of Cathodized Copper Oxide Thin Films
Cathodic electrodeposited copper oxide thin films were prepared using 0.1 M aqueous (distilled water) copper sulphate solution onto the surface of stainless steel substrates. Deposited samples were characterized for structural and morphological analysis using XRD and SeM. Prepared samples were also analyzed using cyclic voltammetry, charge discharge and impedance spectroscopy. electrode shows n...
متن کاملCurrent-Voltage Relations for Electrochemical Thin Films
The dc response of an electrochemical thin film, such as the separator in a microbattery, is analyzed by solving the Poisson-Nernst-Planck equations, subject to boundary conditions appropriate for an electrolytic/galvanic cell. The model system consists of a binary electrolyte between parallel-plate electrodes, each possessing a compact Stern layer, which mediates Faradaic reactions with nonlin...
متن کاملProperties and Sensor Performance of Zinc Oxide Thin Films
Reactively sputtered ZnO thin film gas sensors were fabricated onto Si wafers. The atmosphere dependent electrical response of the ZnO micro arrays was examined. The effects of processing conditions on the properties and sensor performance of ZnO films were investigated. Using AFM, SEM, XRD and WDS, the O2/Ar ratios during sputtering and Al dopant were found to control the property of ZnO films...
متن کاملCharacterization of bias magnetron sputtered tantalum oxide films for capacitors
Tantalum oxide films have been deposited by sputtering of tantalum target in an oxygen partial pressure of 2x10 mbar under various substrate bias voltages in the range from 0 to -150 V on glass and silicon substrates held at room temperature. The influence of substrate bias voltage on the chemical binding configuration, crystallographic structure, electrical and dielectric properties has been s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research Express
سال: 2020
ISSN: 2053-1591
DOI: 10.1088/2053-1591/ab7ced