Tandem rapid manufacturing of Inconel-625 using laser assisted and plasma transferred arc depositions
نویسندگان
چکیده
منابع مشابه
Laser clading of Inconel 625 on ASTM A575 steel
In this research, the microstructure of Inconel 625 cladded layer on ASTM A575 steel has been investigated. By examining different parameters, the optimal single-pass sample with the least amount of dilution, porosity and fusion and suitable wetting angle was determined. Then cladding process with the optimal parameter was performed. The microstructure of the cladding layer was evaluated from t...
متن کاملLaser clading of Inconel 625 on ASTM A575 steel
In this research, the microstructure of Inconel 625 cladded layer on ASTM A575 steel has been investigated. By examining different parameters, the optimal single-pass sample with the least amount of dilution, porosity and fusion and suitable wetting angle was determined. Then cladding process with the optimal parameter was performed. The microstructure of the cladding layer was evaluated from t...
متن کاملPROCESS CONTROL AND DEFECTS IN Ti-6Al-4V ADDITIVE MANUFACTURING, USING PLASMA TRANSFERRED ARC (PTA) TECHNIQUES
Defects during Plasma Transfer Arc (PTA) beam fusion additive manufacturing (AM) processing of Ti-6Al-4V, including lack of fusion, porosity variations, and solidification cracking, have been monitored using near infrared (1.62 μm) imagery at 300 Hz, 300 μm spatial resolution and melt pool sizes of greater than 12μ. The temperature evolution exhibits a periodic temperature modulation of more th...
متن کاملEvaluation of microstructure and corrosion behavior of dissimilar laser joint between Inconel 625 and AISI 430 ferritic stainless steel
Dissimilar weld joints between stainless steels and nickel based super alloys are extensively used in petrochemical, gas and oil applications. These joints jave great challenges from metallurgical transformations point of view. In this research, microstructural evolutions and corrosion behavior of laser weld joint between Inconel 625 and AISI 430 ferritic stainless steel were investigated. Ferr...
متن کاملEvaluation of microstructure and corrosion behavior of dissimilar laser joint between Inconel 625 and AISI 430 ferritic stainless steel
Dissimilar weld joints between stainless steels and nickel based super alloys are extensively used in petrochemical, gas and oil applications. These joints jave great challenges from metallurgical transformations point of view. In this research, microstructural evolutions and corrosion behavior of laser weld joint between Inconel 625 and AISI 430 ferritic stainless steel were investigated. Ferr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Manufacturing
سال: 2013
ISSN: 2095-3127,2195-3597
DOI: 10.1007/s40436-013-0044-z