Taguchi Optimization of Surface Roughness and Material Removal Rate in CNC Milling of Polypropylene + 5wt.% Quarry Dust Composites
نویسندگان
چکیده
Abstract The Taguchi optimization technique was utilized to determine the optimal milling parameters that can be used in end face CNC operation of polypropylene+5wt.% quarry dust using high-speed steel (HSS) tool. Three input i.e. feed rate (f), cutting speed spindle (N) and depth cut (d c ) were optimized while considering surface roughness (Ra) machined composite material removal (MRR) during machining as responses experimental design. From results, (100 rpm) (120 mm/min) most important control which greatly influence at 41.4% 28.8% contribution respectively. In case rate, (0.8 mm) dominating factor 98% contribution.
منابع مشابه
Efficient CNC Milling by Adjusting Material Removal Rate
This paper describes a combined mathematicalgraphical approach for optimum tool path planning in order to improve machining efficiency. A methodology has been used that stabilizes machining operations by adjusting material removal rate in pocket milling operations while keeping cutting forces within limits. This increases the life of cutting tool and reduces the risk of tool breakage, machining...
متن کاملOptimization of Material Removal Rate and Surface Roughness for WEDM of Titanium Alloy (Ti-4.5Al-2V) Using Taguchi Method
In this paper, wire electric discharge machining (WEDM) of Titanium alloy (Ti-4.5Al-2V) is studied. In WEDM, the prime objective in cutting operation is to achieve the highest possible cutting speed along with desirable surface finish without sacrificing productivity. It is evident that a high material removal rate and a very good surface finish can never be achieved simultaneously in WEDM. Sel...
متن کاملOptimization of surface roughness in CNC end milling using response surface methodology and genetic algorithm
Pre-hardened steel (P20) is a widely used material in the production of moulds/dies due to less wear resistance and used for large components. In this study, minimization of surface roughness has been investigated by integrating design of experiment method, Response surface methodology (RSM) and genetic algorithm. To achieve the minimum surface roughness optimal conditions are determined. The e...
متن کاملRoughness modeling and optimization in CNC end milling using response surface method: effect of workpiece material variation
Influence of machining parameters, viz., spindle speed, depth of cut and feed rate, on the quality of surface produced in CNC end milling is investigated. In the present study, experiments are conducted for three different workpiece materials to see the effect of workpiece material variation in this respect. Five roughness parameters, viz., centre line average roughness, root mean square roughn...
متن کاملExperimental investigation of Material removal rate in CNC turning using Taguchi method
Machining of medium Brass alloy is very difficult. There are a number of parameters like cutting speed, feed and depth of cut etc. which must be given consideration during the machining of medium Brass alloy. This study investigates the effects of process parameters on Material Removal Rate (MRR) in turning of C34000. The single response optimization problems i.e. optimization of MRR is solved ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP conference series
سال: 2021
ISSN: ['1757-899X', '1757-8981']
DOI: https://doi.org/10.1088/1757-899x/1107/1/012040