T-Shaped Transmission Line Fault Location Based on Phase-Angle Jump燙hecking
نویسندگان
چکیده
In order to effectively solve the dead-zone and low-precision of T-shaped transmission line fault location, a new location algorithm based on phase-angle jump checking is proposed in this paper. Firstly, 3-terminal synchronous fundamental positive sequence voltage current phasors are extracted substituted into branch distance function realize selection when occurs; Secondly, use condition phasor at point equal calculate all roots (including real root virtual roots); Finally, check used for calculation, then only can be determined as actual distance, thereby achieving purpose high-precision location. MATLAB simulation results show that feasible effective with high accuracy good versatility.
منابع مشابه
Fault Detection in Transmission Line by Magnitude and Phase Angle Extraction based on Neuro – Fuzzy Approach
The main aim of this paper is to detection and classifies the various types of ground and line faults in transmission line. A new current decomposition is proposed in order to derive the positive, negative and zero current components. The faults may be an insulation failure of conductors and cables, lightning or accidental faulty operation of any connected equipment. In a transmission line dete...
متن کاملWavelet Based Analysis for Transmission Line Fault Location
Abstract This paper presents wavelet based analysis for transmission line fault location. Faults in power transmission lines cause transients that travel at a speed close to the speed of light and propagate along the line as traveling waves (TWs). Traveling wave theory is utilized in capturing the travel time of the transients along the monitored lines between the fault point and the protective...
متن کاملInfluence of the Line Parameters in Transmission Line Fault Location
In the paper, two fault location algorithms are presented for transmission lines which use the line parameters to estimate the distance to the fault. The first algorithm uses only the measurements from one end of the line and the positive and zero sequence parameters of the line, while the second one uses the measurements from both ends of the line and only the positive sequence parameters of t...
متن کاملFault Location on Compensated Transmission Lines without Current Measurement
This paper presents a novel fault location method for series compensated transmission lines. It is established based on synchronized voltages sampling and Thevenin impedance from both ends of series compensated transmission line. The method is based on the use of phasor measurement units (PMU) technology which is aimed to be independent of current measurements, fault type, fault resistance, fau...
متن کاملFault location and classification in non-homogeneous transmission line utilizing breaker transients
In this paper, a single-ended fault location method is presented based on a circuit breaker operation using the frequencies of traveling waves. The proposed method receives the required data from voltage traveling waves with the aid of Fast Fourier Transform (FFT) and Wavelet Transform. Then, the Artificial Neural Network (ANN) identifies fault type and determines its location. In order to eval...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energy Engineering
سال: 2022
ISSN: ['0199-8595', '1546-0118']
DOI: https://doi.org/10.32604/ee.2022.020344