Synthesis and Characterization of CeO2/CuO Nanocomposites for Photocatalytic Degradation of Methylene Blue in Visible Light

نویسندگان

چکیده

Removal of hazardous organic dyes from polluted water bodies requires the introduction strong adsorbents and photocatalysts to industrial wastewaters. Herein, photocatalytic CeO2 nanoparticles CeO2/CuO nanocomposite were synthesized following a co-precipitation method for low cost elution methylene blue (MB) water. The crystallinity surface structure as-prepared materials have been analyzed using characterization techniques including X-ray powder diffraction (XRPD), field emission scanning electron microscopy (FE-SEM), energy-dispersive spectroscopy (EDS), ultra-violet visible (UV–Vis), Fourier-transform infrared (FTIR). average particle size both nano scaled samples approximately 20–30 nm. properties investigated under light against (MB). results showed 91% photodegradation MB pollutant in 3 h as monitored by UV–Vis spectroscopy. Absorbance peaks appeared at around 670 nm corresponding degradation MB. Such output displayed effectiveness Ce nanocomposites environmental benefits. Hence, could be useful treatment wastewaters removing dye.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Visible light photocatalytic activity of MWCNT/TiO2 using the degradation of methylene blue

Multi-walled carbon nanotubes (MWCNT)-doped TiO2 thin films were synthesized by the dip-coating method. The obtained products were characterized by SEM, EDX, XRD, and UV-vis absorption spectroscopy. The XRD patterns showed the presence of anatase phase. Absorption spectrum of MWCNT-doped TiO2 revealed a red shift in the optical absorption edge due to carbon doping. The photocatalytic properties...

متن کامل

Photocatalytic degradation of methylene blue by 2 wt.% Fe doped TiO2 nanopowder under visible light irradiation

In this paper, 2wt.% Fe doped TiO2 nanopowder was prepared by a combination of sol-gel and mechanical alloying methods. The mechanical alloying of Fe powder with Ti(OH)4 gel produced from the sol-gel method was used to produce Fe doped TiO2 nanopowder. The synthesized samples were characterized by X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM) and diffuse reflectan...

متن کامل

Hydrothermally synthesized nanocrystalline Nb2O5 and its visible-light photocatalytic activity for the degradation of congo red and methylene blue

Nb2O5 nanoparticles were synthesized by the hydrothermal method. Structural, morphological and elemental analysis of synthesized Nb2O5 nanoparticles was carried out using X-ray diffraction (XRD), scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy, respectively. The average crystal size calculations were performed on the basis ...

متن کامل

Hydrothermally synthesized nanocrystalline Nb2O5 and its visible-light photocatalytic activity for the degradation of congo red and methylene blue

Nb2O5 nanoparticles were synthesized by the hydrothermal method. Structural, morphological and elemental analysis of synthesized Nb2O5 nanoparticles was carried out using X-ray diffraction (XRD), scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy, respectively. The average crystal size calculations were performed on the basis ...

متن کامل

Visible Light-Induced Degradation of Methylene Blue in the Presence of Photocatalytic ZnS and CdS Nanoparticles

ZnS and CdS nanoparticles were prepared by a simple microwave irradiation method under mild conditions. The obtained nanoparticles were characterized by XRD, TEM and EDX. The results indicated that high purity of nanosized ZnS and CdS was successfully obtained with cubic and hexagonal crystalline structures, respectively. The band gap energies of ZnS and CdS nanoparticles were estimated using U...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Coatings

سال: 2021

ISSN: ['2079-6412']

DOI: https://doi.org/10.3390/coatings11030305