Switching Optimization for Class-G Audio Amplifiers with Two Power Supplies
نویسندگان
چکیده
منابع مشابه
HIGH-VOLTAGE CLASS-D POWER AMPLIFIERS: DESIGN AND OPTIMIZATION Haifeng Ma HIGH-VOLTAGE CLASS-D POWER AMPLIFIERS: DESIGN AND OPTIMIZATION
i ABSTRACT Nowadays transducers are ubiquitous as interfaces between the increasingly digital world and the real physical world. The same holds for the power amplifiers driving them. This thesis focuses on the design and optimization of high-voltage class-D amplifiers, which are used for driving capacitive piezoelectric actuator loads in active vibration/noise control applications. The main obj...
متن کاملClass-D Audio Amplifiers with Negative Feedback
There are many different designs for audio amplifiers. Class-D, or switching, amplifiers generate their output signal in the form of a high-frequency square wave of variable duty cycle (ratio of on time to off time). The square-wave nature of the output allows a particularly efficient output stage, with minimal losses. The output is ultimately filtered to remove components of the spectrum above...
متن کاملClass of High-Efficiency Tuned Switching Power Amplifiers
The previous literature on tuned power amplifiers has not made clear the fundamental differences between amplifiers in which the output device acts 1) as a current source, or 2) as a switch. Previous circuits have often operated in contradiction to their design assumptions, resulting in the need for “cut-and-try” design. The new class of amplifiers deseribed here is based on a load network synt...
متن کاملMagnetics Design for Switching Power Supplies
Figure 1-1 Transformer Equivalent Circuit Introduction Experienced SwitchMode Power Supply designers know that SMPS success or failure depends heavily on the proper design and implementation of the magnetic components. Parasitic elements inherent in high frequency transformers or inductors cause a variety of circuit problems including: high losses, high voltage spikes necessitating snubbers or ...
متن کاملActive Power Line Filters for Switching Power Supplies
This paper analyses two schemes of single-stage diode-switched active filters used in new switching power supplies designs to improve the power factor. From the point of view of the power flow, the distortion reduction is based on the improvement of the power conversion processes. Most of the ca/cc switching power supplies consists of two separated parts: a rectifier – in most cases a diode bri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Circuits and Systems
سال: 2012
ISSN: 2153-1285,2153-1293
DOI: 10.4236/cs.2012.31012