Survivability of MEMS Packages at High-G Loads
نویسندگان
چکیده
منابع مشابه
Plastic Hermetic Packages for MEMS?
The sealed hermetic package is over 100 years old if we include cathode ray and vacuum tubes. While the package has changed, the idea of making a near-perfect gas-tight enclosure has remained constant. The metal and ceramic full hermetic package may be required for applications that cannot use the non-hermetic plastic package, but is there an intermediate package choice? During the last few yea...
متن کاملResponse of Mems Devices under Shock Loads
There is strong experimental evidence for the existence of strange modes of failure of MEMS devices under shock. Such failures have not been explained with conventional models of MEMS. These failures are characterized by overlaps between moving microstructures and stationary electrodes, which cause electrical shorts. This work presents a model and simulation of MEMS devices under the combinatio...
متن کاملMeasurements of True Leak Rates of MEMS Packages
Gas transport mechanisms that characterize the hermetic behavior of MEMS packages are fundamentally different depending upon which sealing materials are used in the packages. In metallic seals, gas transport occurs through a few nanoscale leak channels (gas conduction) that are produced randomly during the solder reflow process, while gas transport in polymeric seals occurs through the bulk mat...
متن کاملPlastic Hermetic Packages for MEMS , MOEMS & Optoelectronic Devices ?
Introduction The full hermetic package for electronics and optoelectronic (OE) devices was first developed in the 1800’s and has served these industries well. The earliest optoelectronic devices, cathode ray tubes (CRT) demonstrated in the late 1800’s, used a sealed glass vacuum enclosure. The Braun Tube, for example, was a scanning CRT display system that used a glass envelope to seal out the ...
متن کاملDesign of Novel High Sensitive MEMS Capacitive Fingerprint Sensor
In this paper a new design of MEMS capacitive fingerprint sensors is presented. The capacitive sensor is made of two parallel plates with air gap. In these sensors, the capacitance changes is very important factor. It is caused by deformation of the upper electrode of sensor. In this study with making slots in upper electrode, using T-shaped protrusion on diaphragm in order to concentrate the f...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Optomechatronics
سال: 2014
ISSN: 1559-9612,1559-9620
DOI: 10.1080/15599612.2014.972600