Survey of Injection-System Design

نویسندگان

چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

simulation and design of electronic processing circuit for restaurants e-procurement system

the poor orientation of the restaurants toward the information technology has yet many unsolved issues in regards to the customers. one of these problems which lead the appeal list of later, and have a negative impact on the prestige of the restaurant is the case when the later does not respond on time to the customers’ needs, and which causes their dissatisfaction. this issue is really sensiti...

15 صفحه اول

Development of an Intelligent Cavity Layout Design System for Injection Molding Dies (RESEARCH NOTE)

This paper presents the development of an Intelligent Cavity Layout Design System (ICLDS) for multiple cavity injection moulds. The system is intended to assist mould designers in cavity layout design at concept design stage. The complexities and principles of cavity layout design as well as various dependencies in injection mould design are introduced. The knowledge in cavity layout design is ...

متن کامل

Towards Design of System Hierarchy (research survey)

The paper addresses design/building frameworks for some kinds of tree-like and hierarchical structures of systems. The following approaches are examined: (1) expert-based procedure, (2) hierarchical clustering; (3) spanning problems (e.g., minimum spanning tree, minimum Steiner tree, maximum leaf spanning tree problem; (4) design of organizational " optimal " hierarchies; (5) design of multi-la...

متن کامل

a structural survey of the polish posters

تصویرسازی قابلیتهای فراوانی را دارا است

15 صفحه اول

Updated Design of the Italian Superb Factory Injection System

The ultra high luminosity B-factory (SuperB) project of INFN [1, 2] requires a high performance and reliable injection system, providing electrons at 4 GeV and positrons at 7 GeV, to fulfill the very tight requirements of the collider. Due to the short beam lifetime, continuous injection of electrons and positrons in both High Energy Ring (HER) and Low Energy Ring (LER) is necessary to keep the...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: IEEE Transactions on Nuclear Science

سال: 1965

ISSN: 0018-9499

DOI: 10.1109/tns.1965.4323734