Surface Tension and Density of Fe–Mn Melts
نویسندگان
چکیده
منابع مشابه
Density and Temperature Dependencies of Liquid Surface Tension
In this paper the density and temperature dependencies of surface tension are investigated. Using the Lennard-Jones (12,6), as an effective pair interaction potential, a linear expression is derived for isotherms of g /r2 versus r2 for some normal and ChloroFluoroCarbons (CFCs)</...
متن کاملdensity and temperature dependencies of liquid surface tension
in this paper the density and temperature dependencies of surface tension are investigated. using the lennard-jones (12,6), as an effective pair interaction potential, a linear expression is derived for isotherms of g /r2 versus r2 for some normal and chlorofluorocarbons (cfcs) fluids, where is surface tension and r = 1/v is molar density. the linearity behavior of the derived equation is wel...
متن کاملOn the Role of Surface Tension in the Migration of Melts and Fluids
It is shown that surface tension can cause redistribution of melt in a partially molten medium, in accordance with a non-linear diffusion equation for the melt fraction. The associated diffusivity D depends on the surface energy and is positive (stable) for dihedral angle <60 ø and negative (unstable) for dihedral anise >•0ø•1 In the more likely stable case, D ~ . 10 cm .s is typical •or •antle...
متن کاملDensity, Viscosity and Surface Tension of Whey Protein Concentrate Solutions
We have determined the density, rheological behavior and surface tension of whey protein concentrate (WPC) solutions. Densities (r) were measured at concentrations of 0.05–0.40 w/w at temperatures of 20–35C. The results were expressed as a function of temperature and mass fraction (w). This function fit the data with deviations of less than 0.4%. Apparent viscosities (ha) for WPC solutions with...
متن کاملDensity profiles and surface tension of polymers near colloidal surfaces
The surface tension of interacting polymers in a good solvent is calculated theoretically and by computer simulations for a planar wall geometry and for the insertion of a single colloidal hard sphere. This is achieved for the planar wall and for the larger spheres by an adsorption method, and for smaller spheres by a direct insertion technique. Results for the dilute and semidilute regimes are...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Steel in Translation
سال: 2020
ISSN: 0967-0912,1935-0988
DOI: 10.3103/s0967091220010118