Surface roughness of Ti6Al4V samples produced by laser powder bed fusion for bone implants
نویسندگان
چکیده
This study describes the surface roughness of heat-treated Ti6Al4V ELI samples without finishing (as-built condition) depending on position build plate. Surface was studied at top and side surfaces horizontal vertical using a profilometer Scanning Electron Microscopy. Morphology tested is shown. It shown that had different morphologies, but they fairly close values, since formation mainly associated with sticking powder material both upper surfaces. found were far away from argon inlet recoater start line higher roughness.
منابع مشابه
Functionalization of Biomedical Ti6Al4V via In Situ Alloying by Cu during Laser Powder Bed Fusion Manufacturing
The modern medical industry successfully utilizes Laser Powder Bed Fusion (LPBF) to manufacture complex custom implants. Ti6Al4V is one of the most commonly used biocompatible alloys. In surgery practice, infection at the bone-implant interface is one of the key reasons for implant failure. Therefore, advanced implants with biocompatibility and antibacterial properties are required. Modificatio...
متن کاملLaser Surface Modification of Ti6Al4V Implants
To improve the biocompatibility of implants, surface medication is a common practice. Depending on the surface medication process, the physical and/or chemical properties of the surface are altered, keeping the bulk properties same. The flexibility and wide application potential of laser as a surface modification tool gives it certain advantages over the traditional physical and chemical proces...
متن کاملStudy of the Microstructure and Cracking Mechanisms of Hastelloy X Produced by Laser Powder Bed Fusion
Hastelloy X (HX) is a Ni-based superalloy which suffers from high crack susceptibility during the laser powder bed fusion (LPBF) process. In this work, the microstructure of as-built HX samples was rigorously investigated to understand the main mechanisms leading to crack formation. The microstructural features of as-built HX samples consisted of very fine dendrite architectures with dimensions...
متن کاملan experimental investigation of surface roughness produced by micromilling of ti6al4v alloy under different lubrication and cooling conditions
0
متن کاملEffects of Laser Processing Parameters on Texturized Layer Development and Surface Features of Ti6Al4V Alloy Samples
Surface engineering is widely used in different areas, such as the aerospace industry or the biomechanical and medical fields. Specifically, laser surface modification techniques may obtain specific surface finishes for special applications. In texturing laser procedures, the control of processing parameters has a great influence on the geometry and characteristics of the treated area. When the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC web of conferences
سال: 2022
ISSN: ['2261-236X', '2274-7214']
DOI: https://doi.org/10.1051/matecconf/202237011001