Surface Roughness and Hydrophilicity of Titanium after Anodic Oxidation
نویسندگان
چکیده
منابع مشابه
Titanium oxide nanotube arrays prepared by anodic oxidation
Titanium oxide nanotubes were fabricated by anodic oxidation of a pure titanium sheet in an aqueous solution containing 0.5 to 3.5 wt% hydrofluoric acid. These tubes are well aligned and organized into high-density uniform arrays. While the tops of the tubes are open, the bottoms of the tubes are closed, forming a barrier layer structure similar to that of porous alumina. The average tube diame...
متن کاملSurface analysis of anodic oxide films containing phosphorus on titanium.
PURPOSE To examine the effect of phosphoric acid solution on the anodic oxide film of titanium. MATERIALS AND METHODS Commercially pure grade 2 titanium specimens were prepared and anodized in phosphoric acid solution at a constant current density (70 A/m2). Specimens were evaluated by means of scanning electron microscopy, x-ray diffraction analysis, electron probe microanalysis, energy-disp...
متن کاملDepletion of surface accumulation charge in InN by anodic oxidation
Si-doped InN layer by molecular beam epitaxy was subjected to anodic oxidation in 0.1 M potassium hydroxide KOH electrolyte and characterized by electrochemical methods to derive carrier profile at the InN surface. The obtained results were compared to the characteristics of a planar resistor structure and vertical metal-oxide-semiconductor MOS diodes with Ni-metal contacts on the oxidized InN....
متن کاملAnodic oxidation of titanium for implants and prosthesis: processing, characterization and potential improvement of osteointegration
Among all biomaterials used for bone replacement, it is recognized that both commercially pure titanium (Ti c.p.) and Ti6Al4V alloy are the materials that show the best in vivo performance due to their excellent balance between mechanical, physical-chemical and biofunctional properties. However, one of its main drawbacks, which compromise the service reliability of the implants and its osteoint...
متن کاملEnamel Surface Roughness after Orthodontic Bracket Debonding and Composite Resin Removal by Two Types of Burs
Objective: Increased enamel surface roughness following orthodontic bracket debonding leads to increased plaque accumulation and enamel decalcification. Therefore, different methods are employed to achieve smoother enamel surfaces after bracket debonding. This study compared enamel surface roughness following orthodontic bracket debonding and composite resin removal using white stone and tung...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Rare Metal Materials and Engineering
سال: 2016
ISSN: 1875-5372
DOI: 10.1016/s1875-5372(16)30088-1