Surface roughening of Nylon 6 during plastic deformation.

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Saturation of surface roughening instabilities by plastic deformation

Surface roughening instabilities driven by a competition between elastic and surface energy contributions are shown to be saturated by plastic energy dissipation. It is shown that these morphological instabilities do not experience unbounded growth as predicted by consideration of elastic energy alone and that their growth is limited by dislocation emission from higher curvature grooves. © 2008...

متن کامل

Roughening of fracture surfaces: the role of plastic deformation.

Post mortem analysis of fracture surfaces of ductile and brittle materials on the microm-mm and the nm scales, respectively, reveal self-affine cracks with anomalous scaling exponent zeta approximately 0.8 in three dimensions and zeta approximately 0.65 in two dimensions. Attempts to use elasticity theory to explain this result failed, yielding exponent zeta approximately 0.5 up to logarithms. ...

متن کامل

correlation between twinning and surface rumpling phenomenon during plastic deformation of austenitic manganese steel

in this paper, the correlation between the surface rumpling and cracking phenomena with twinning mechanism during plastic deformation of hadfield steel has been investigated. the effect of stacking fault energy and the amount of strain are evaluated. the experimental samples with specific amounts of carbon, manganese and aluminum resulting in different stacking fault energies, were produced usi...

متن کامل

Finite element analysis of elastic-plastic solids under Vickers indentation: surface deformation

Finite element modeling has been used to study the development of surface deformation during indentation with a Vickers indenter. A wide range of materials with different elastic modulus and yield stresses are examined. Results show that in a pyramidal indentation process, for a perfectly plastic material, sinking-in during loading can change to pile-up in unloading. This phenomenon depends on ...

متن کامل

PLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE

An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Society of Materials Science, Japan

سال: 1991

ISSN: 1880-7488,0514-5163

DOI: 10.2472/jsms.40.526