Surface mines composite slope deformation mechanisms and stress distribution
نویسندگان
چکیده
منابع مشابه
Seasonal slope surface deformation measured with TLS
In temperate European climates, soil water removal due to vegetation transpiration peaks in summer and soil rewetting from higher levels of precipitation occurs in winter. In clays of high plasticity, the seasonal cycles of drying and wetting cause the soil to experience a volumetric change, resulting in seasonal shrinking and swelling. For a clay slope exhibiting volume change, such behaviour ...
متن کاملDeformation Characteristics of Composite Structures
The composites provide design flexibility because many of them can be moulded into complex shapes. The carbon fibre-reinforced epoxy composites exhibit excellent fatigue tolerance and high specific strength and stiffness which have led to numerous advanced applications ranging from the military and civil aircraft structures to the consumer products. However, the modelling of the beams undergoin...
متن کاملPLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE
An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....
متن کاملA review on stress distribution, strength and failure of bolted composite joints
In this study, analytical models considering different material and geometry for both single and double-lap bolted joints were reviewed for better understand how to select the proper model for a particular application. The survey indicades that the analytic models selected for the adhesively single or double bolted lap joints, as well as T, scarf, and stepped joints, with linear material pr...
متن کاملSimulation of Foaming and Deformation for Composite Aluminum Foams
In this study, at the first stage, the rupture criterion of bubbles wall in Aluminum metal foam liquid was investigated by using Lattice Boltzmann. The two phases modeling were accomplished by using a modified Shan-Chen model. This model was run for several bubbles in A356+3wt.%SiC melt system. Then, bubbles morphologies (virtual metallographic) for A356+3wt.%SiC foams were simulated. Results s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mining of Mineral Deposits
سال: 2020
ISSN: 2415-3435,2415-3443
DOI: 10.33271/mining14.04.001