Surface Integrity of Cemented Carbides Machined by Electrical Discharge Machining after Polishing.
نویسندگان
چکیده
منابع مشابه
Wear Characterization of Cemented Carbides (WC–CoNi) Processed by Laser Surface Texturing under Abrasive Machining Conditions
Cemented carbides are outstanding engineering materials widely used in quite demanding material removal applications. In this study, laser surface texturing is implemented for enhancing, at the surface level, the intrinsic bulk-like tribological performance of these materials. In this regard, hexagonal pyramids patterned on the cutting surface of a tungsten cemented carbide grade (WC–CoNi) have...
متن کاملMechanical Surface Treatments of Ti-6Al-4V Miniplate Implant Manufactured by Electrical Discharge Machining (TECHNICAL NOTE)
Present work aims at multi-mechanical surface treatment of Ti-6Al-4V based-miniplate implant manufactured by electrical discharge machining (EDM) for biomedical use. Mechanical surface treatment consists of consequent use of ultrasonic cleaning, rotary tumbler polishing, and brushing. Surface layers are analyzed employing scanning electron microscopy and energy dispersive X-ray spectroscopy. Al...
متن کاملGrinding effects on surface integrity and mechanical strength of WC-Co cemented carbides
In this study, the correlation existing among grinding, surface integrity, and flexural strength is investigated for WC-Co cemented carbides (hardmetals). A fine-grained WC-13 wt % Co grade and three different surface conditions: (1) ground, (2) mirror-like polished (reference), and (3) ground plus high-temperature annealed, are investigated. Surface integrity and mechanical characterization is...
متن کاملInfluence of electrical discharge machining on sliding friction and wear of WC–Ni cemented carbide
Tribological characteristics of fine-grained WC–8 wt%Ni with different surface finishing conditions corresponding to sequential wire electrical discharge machining (wire-EDM) or grinding were investigated by performing dry reciprocating sliding experiments on TE77 pin-on-plate equipment with WC–6 wt%Co as mating material. Surface finishes and wear surfaces were characterized using surface topog...
متن کاملEDM machinability and dry sliding friction of WC-Co cemented carbides
A number of WC-Co cemented carbides with 6–12 wt. % Co were machined and surface finished by grinding or Electrical Discharge Machining (EDM). EDM was executed in deionised water through several consecutive gradually finer steps. Correlations between Material Removal Rate (MRR), surface finish and EDM parameters were derived. The quality and integrity of surface finishes were analysed by Scanni...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Japan Society of Electrical Machining Engineers
سال: 2001
ISSN: 1881-0888,0387-754X
DOI: 10.2526/jseme.35.12