Surface Characteristics Analysis of Gas Carburized New Hot Working Tool Steel
نویسندگان
چکیده
منابع مشابه
Laser Grooving of Surface Cracks on Hot Work Tool Steel
Repair welding (RW) with wire cladding is a common procedure to extend the in-service life of heavily loaded tool parts for die and mould industries 1-5 . The main advantages of repair welding are short downtime and cost efficiency compared to production of new tool part. Repair welding in general lowers the tool cost in the final part and enables higher added value to the die casting and injec...
متن کاملHot Forming of Aisi A2 Tool Steel
In order to optimize the hot forming process of tool steels, further improvement of flow stress prediction and additional knowledge on hot deformability, especially at lower and upper limits of the hot working range, are required. The hot working ranges for these steels are very narrow as a consequence of the role of alloying elements, which form carbides. Carbides improve tool steel’s hardenab...
متن کاملEVALUATING HOT DEFORMATION BEHAVIOR OF W360 TOOL STEEL BY HOT COMPRESSION TEST
In this research, the hot deformation behavior of W360 tool steel was investigated using hot compression test at 1000-1200°C and strain rates of 0.001, 0.01, 0.1, and 1 s-1. According to the results, dynamic recrystallization was found the most important restoration factor of this alloy during hot deformation. Recrystallization was enhanced with an increase in temperature and strain rate. Also,...
متن کاملEVALUATION OF THE MECHANICAL PROPERTIES OF NIOBIUM MODIFIED CAST AISI H 13 HOT WORK TOOL STEEL
Abstract: mechanical properties of AISIH 13 hot-work tool steel have been studied. Cast samples made of the modified new steel were homogenized and austenitized at different conditions, followed by tempering at the specified temperature ranges. Hardness, red hardness, three point bending test and Charpy impact test were carried out to evaluate the mechanical properties together with characteriz...
متن کاملStatistical discriminator of surface defects on hot rolled steel
A statistical approach to defect detection and discrimination has been applied to the case of hot rolled steel. The probability distribution of pixel intensities has been estimated from a small set of images without defects, and this distribution is used to select pixels with unlikely values as candidates for defects. Discrimination of true defects from random noise pixels is achieved by a dyna...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: e-Journal of Surface Science and Nanotechnology
سال: 2011
ISSN: 1348-0391
DOI: 10.1380/ejssnt.2011.430