Supersonic Flutter of Conical Shells: II Wind Tunnel Tests
نویسندگان
چکیده
منابع مشابه
Supersonic Wind - Tunnel Flutter Tests of Two Rectangular Wings
Two rectangular wings of aspect ratio 4 were flutter tested in a supersonic wind tunnel at Mach numbers 1·6 and 2·0 using a technique in which a structural stiffness was varied to give flutter at the Mach number. The results are in reasonable agreement with calculations using theoretical three-dimensional derivatives and arbitrary wing modes, though in general the calculated critical stiffnesse...
متن کاملSupersonic Blowdown Wind Tunnel Control Using LabVIEW
A computer-based, proportional-integral control system for supersonic blowdown wind tunnels was developed in a LabVIEW environment. The control algorithm is based on numerically integrating the differential equations used to model a supersonic blowdown wind tunnel in which the proportional and integral control terms were added and tuned in a simulation to determine their appropriate values. Val...
متن کاملA Low Cost Numerical Simulation of a Supersonic Wind-tunnel Design
In the present paper, a supersonic wind-tunnel is designed to maintain a flow with Mach number of 3 in a 30cm×30cm test section. An in-house CFD code is developed using the Roe scheme to simulate flow-field and detect location of normal shock in the supersonic wind-tunnel. In the Roe scheme, flow conditions at inner and outer sides of cell faces are determined using an upwind biased algorithm. ...
متن کاملWind tunnel tests of a free yawing downwind wind turbine
This research paper presents preliminary results on a behavioural study of a free yawing downwind wind turbine. A series of wind tunnel tests was performed at the TU Delft Open Jet Facility with a three bladed downwind wind turbine and a rotor radius of 0.8 meters. The setup includes an off the shelf three bladed hub, nacelle and generator on which relatively flexible blades are mounted. The to...
متن کاملCFD for Better Understanding of Wind Tunnel Tests
CFD requires validation for complicated flow problems involving complex physics such as turbulence. Wind tunnels are still the most commonly used validation tools for CFD including physical modelling although some limited use of reliable DNS data base for simple geometries is recently becoming possible. One can observe the trend that a higher and higher demand on the accuracy of the wind tunnel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Aeronautical and Space Sciences
سال: 1977
ISSN: 0021-4663
DOI: 10.2322/jjsass1969.25.95