Superplasticity of hypo-eutectoid Al-Zn alloy sheets.
نویسندگان
چکیده
منابع مشابه
Damping Capacity of Hypo-Eutectic Zn-Al Alloys
Damping capacity of hypo-eutectic Zn-Al alloys as a function of rolling ratio is investigated. Effect of heat treatment after cold rolling on the damping capacity is discussed. Damping tests were carried out using the method of the free decay of vibrations in bending oscillation. With an increase in rolling reduction, the damping capacity was increased. As the results of tensile and hardness te...
متن کاملDAMPING CAPACITY AND MECHANICAL PROPERTIES OF Zn-Al ALLOY CASTINGS
This paper describes damping capac i t y and mechanical p roper t ies o f Zn-8-20%A1 and Zn-8-20%Al-0.02-0.04XMg a l l o y cast ings. Zn-8-20%A1 a l l o y casti ngs show h igh damping when quenched from 573K. Small amount o f Mg a d d i t i o n t o these a l l o y cast ings lowers damping capaci ty considerably b u t e f f e c t i v e t o reduce decomposition through aging a t 423K f o r 48hrs ...
متن کاملEnhanced superplasticity in commercially pure titanium alloy
The superplasticity of commercially pure titanium alloy at high temperature was studied and the dynamic recrystallization phenomenon of the alloy was investigated by using electron back scattered diffraction. A two-step deformation method was used to increase the ductility of the alloy from 188% to 243%. 2004 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1988
ISSN: 0451-5994
DOI: 10.2464/jilm.38.159