Superplastic Behaviour of 5083 Aluminium Alloy Bearing 0.12wt% Zr.
نویسندگان
چکیده
منابع مشابه
Laser Welding of Aluminium Alloy 5083
There are two laser welding mechanisms, keyhole mode and conduction mode. Keyhole welding is widely used because it produces welds with high aspect ratios and narrow heat affected zones. However keyhole welding can be unstable, as the keyhole oscillates and closes intermittently. This intermittent closure causes porosity due to gas entrapment. Conduction welding, on the other hand, is more stab...
متن کاملWear behaviour of AA6061 aluminium alloy and its composites
This study investigates the wear resistance of four AA6061 MMCs together with the monolithic AA6061 alloy, all in the T6 condition, using a pin-on-disc test. In addition to the widely studied 20 vol.% Saffil MMCs, the present investigation considered a hybrid of 11% Saffil + 20% Sic, and a high volume fraction Sic, MMC. AA6061 + 60% Sic,. The wear behaviour against P400 Sic grit adhesive bonded...
متن کاملSuperplastic Forming of Inconel Alloy 718spf
Superplasticforming (SPF) has become an important manufacturing method for aerospace and fuselage components. The basic reasons for the popularity of this process are reviewed and the compatibilityoffine-grained INCONELB alloy71 8SPF@ to superplasticforming are presented in this paper. The temperature limitations of current aluminum and titanium alloys employed in SPF parts for gas turbine comp...
متن کاملTowards Superplastic Forming of Az31 Magnesium Alloy with Controlled Microstructure
A recent study on post-superplastic forming properties has shown that heating time prior to testing has a major effect on the post-forming properties of superplastically-formed AZ31 Magnesium alloy sheets. To this point, there has been very little examination into the effects of pre-heating or annealing on superplastic forming. In this work, these effects are examined using AZ31 Mg alloy sample...
متن کاملSuperplastic hemispherical Bulge Forming of a Ti-Al-Mn Alloy
Superplastic sheet thermoforming has been identified as a standard processing route for the production of complex shapes, especially in the aerospace industry. Ti-Al-Mn (OT4-1) alloy is currently being used for aero engine components as well as other aerospace applications by forming through a conventional route which is typically cost, labour and equipment intensive. The Ti-Al-Mn alloy (made a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1992
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.41.17