Suitability of Mg-PSZ for hip endo-prosthesis articulation against ultra high molecular weight polyethylene.

Wear of Ultra High Molecular Weight Polyethylene

Properties of crosslinked ultra-high-molecular-weight polyethylene.

Substantially reducing the rate of generation of wear particles at the surfaces of ultra-high-molecular-weight polyethylene (UHMWPE) orthopedic implant bearing components, in vivo, is widely regarded as one of the most formidable challenges in modern arthroplasty. In the light of this, much research attention has been paid to the myriad of endogenous and exogenous factors that have been postula...

Synthesis of high molecular weight polyethylene using FI catalyst

A FI Zr-based catalyst of bis[N-(3,5-dicumylsalicylidene)-2′,6′­diisopropylanilinato]zirconium(IV) dichloride was prepared and used for polymerization of ethylene. The effects of reaction conditions on the polymerization were examined in detail. The increase in ethylene pressure and rise in polymerization temperature up to 35 oC were favorable for catalyst/MAO to raise the catalytic activity as...

Preparation of Ultra High Molecular Weight Polyethylene Using Ziegler-Natta Catalyst System: Optimization of Parameters by Response Surface Methodology

Comparison of periprosthetic tissue digestion methods for ultra-high molecular weight polyethylene wear debris extraction.

There is considerable interest in characterization of wear debris from polyethylene (UHMWPE) bearing components used in total joint replacement. To isolate UHMWPE wear debris, tissue samples must be excised from regions adjacent to revised UHMWPE implant components, followed by exposure to one of many available tissue digestion methods. Numerous studies demonstrate successful digestion, but the...