Submersible rotor disc mixers
نویسندگان
چکیده
Abstract The article presents the most common varieties of low-volume rotary disc mixers. features their design are described, main advantages and disadvantages identified. A description a new submersible rotor-disk mixer is given. It shown that this type can be used to create high-quality emulsions maintain them. installed in overall tanks reactor.
منابع مشابه
Foam Generation in Rotor-Stator Mixers
non-ideality, it will tend to reduce differences between calibraiion and predictior;. To do this of course is not always possible, particularly where the effect of changing dyebath conditions is under consideration, e.g. liquor ratio, electrolyte concentration, pH and dye concentration. To attempt calibration experiments to adequately cover the results of such changes would remove the need for ...
متن کاملMicromixing in a Rotor–Stator Spinning Disc Reactor
This paper presents the micromixing times in a rotor-stator spinning disc reactor. Segregation indices are obtained at different rotational speeds performing the Villermaux-Dushman parallel-competitive reaction scheme. Consequently, the corresponding micromixing times are calculated using the engulfment model, while considering the self-engulfment effect. It was found that the segregation index...
متن کاملSimulation of fully coupled thermomechanical analysis of disc brake rotor
Vehicle braking system is considered as one of the most fundamental safety-critical systems in modern vehicles as its main purpose is to stop or decelerate the vehicle. The frictional heat generated during braking application can cause numerous negative effects on the brake assembly such as brake fade, premature wear, thermal cracks and disc thickness variation (DTV). In the past, surface rough...
متن کاملRF Mixers
The two signals inserted into the two input ports are usually the Local Oscillator signal, and the incoming (for a receiver) or outgoing (for a transmitter) signal. To produce a new frequency (or new frequencies) requires a nonlinear device. In a mixing process if we want to produce an output frequency that is lower than the input signal frequency, then it is called down-conversion and if we wa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP conference series
سال: 2023
ISSN: ['1757-899X', '1757-8981']
DOI: https://doi.org/10.1088/1755-1315/1231/1/012082