Sub‐5 nm Metal Nanogaps: Sub‐5 nm Metal Nanogaps: Physical Properties, Fabrication Methods, and Device Applications (Small 5/2019)
نویسندگان
چکیده
منابع مشابه
Assembly of metal nanoparticles into nanogaps.
The directed assembly of nanoparticles and nanoscale materials onto specific locations of a surface is one of the major challenges in nanotechnology. Here we present a simple and scalable method and model for the assembly of nanoparticles in between electrical leads. Gold nanoparticles, 20 nm in diameter, were assembled inside electrical gaps ranging from 15 to 150 nm with the use of positive a...
متن کاملParallel fabrication of polymer-protected nanogaps.
A method to create an array of sub-5 nm nanogaps with self-aligned holes in a protective polymer overlayer is presented. The parallel formation of the nanogaps, intended for electrical sensing of biomolecules in an aqueous environment, is achieved by electromigration using a simple voltage ramp across parallel-connected electrode patterns with individual constrictions. It was observed that the ...
متن کاملFabrication of Buried Co-Planar Metal-Insulator-Metal Nanojunctions with a Gap Lower than 10 nm
An improvement of a process to fabricate co-planar metal-insulator-metal nanojunctions is presented to reach a gap length much lower than lo nm using a 20 kev e-beam and an AuPd lift-off. The electrodes of the nanojunction are less than loo nm in width and are buried in the Si02 substrate. For the 8 nm nanojunctions, the gap is still filled with Si02 if care is taken about the Si02
متن کاملDirectly addressable sub-3 nm gold nanogaps fabricated by Nanoskiving using self-assembled monolayers as templates.
This paper describes the fabrication of electrically addressable, high-aspect-ratio (>10000:1) nanowires of gold with square cross sections of 100 nm on each side that are separated by gaps of 1.7-2.2 nm which were defined using self-assembled monolayers (SAMs) as templates. We fabricated these nanowires and nanogaps without a clean room or any photo- or electron-beam lithographic processes by ...
متن کاملFabricating nanogaps by nanoskiving.
There are several methods of fabricating nanogaps with controlled spacings, but the precise control over the sub-nanometer spacing between two electrodes-and generating them in practical quantities-is still challenging. The preparation of nanogap electrodes using nanoskiving, which is a form of edge lithography, is a fast, simple and powerful technique. This method is an entirely mechanical pro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Small
سال: 2019
ISSN: 1613-6810,1613-6829
DOI: 10.1002/smll.201970030