Study on work regenerative chatter in traverse grinding.
نویسندگان
چکیده
منابع مشابه
Study of Traverse Grinding Process (1st Report) Accumulation Phenomenon and Size Generation Mechanism in Traverse Grinding
plicated processes on the wheel surf ace along the wheel width. In order to make these processes clear, the experimental analysis of traverse grinding was conducted by widely changing the speed ratio, Kv, the setting depth of wheel, ‡TMT, and the number of total steps, m, (the ratio of the wheel width over the traverse feed per one revolution of the workpiece). The following results were obtain...
متن کاملin translation: translators on their work and what it means
کتاب در باب ترجمه، اثر استر آلن و سوزان برنوفسکی منتشر شده در ماه می 2013 توسط نشریه کلمبیا است. نویسندگان در این کتاب به بررسی 18 مترجم با در نظر گرفتن نقش آثاری که این مترجمان ترجمه کرده اند میپردازند. کتاب به دو بخش تقسیم میشود: " مترجم در جهان" و " کار مترجم" این دو بخش مقالات همیشگی ترجمه و موقعیت خاص ادبیات بیگانه در جهان وسیع امروزی را مورد خطاب قرار میدهد. در این کتاب مقالات متعددی از ن...
Effect of vitrified bond microstructure and volume fraction in the grinding wheel on traverse internal cylindrical grinding of Inconel alloy 600
The following article examines the influence of glass-crystalline bond in grinding wheels with grains made from microcrystalline aluminum oxide, and specifically its effect upon the values of selected operational indicators in the process of traverse internal cylindrical grinding of surfaces made from Inconel® alloy 600. The experimental test results obtained showed that changes in the bond pha...
متن کاملInternal Traverse Grinding – From Single Grain Models to Macroscopic Process Simulations
We present recent advances in the modelling and simulation of Internal Traverse Grinding with electroplated cBN wheels, a novel manufacturing process that is capable of performing a high rate of material removal while maintaining a good surface quality of the finished cylindrical part. The major drawback of this process is a highly concentrated thermal load on the workpiece which can result in ...
متن کاملFundamental Study on Cross Axis Grinding Method
In this study, it is experimentally investigated that the surface generation process in the cross axis grinding method with small diameter grinding wheel. In this grinding method, workpiece surface speed and sum of both wheel working surface speed and wheel feed rate crossed each other. Therefore, it is the largest characteristic that the cross angle, which is defined as the angle between the w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1990
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.56.1692