Study on Thermal Analysis for Optimization LED Driver ICs
نویسندگان
چکیده
منابع مشابه
Timing Analysis and Optimization for Many-Tier 3D ICs
Tremendous amount of investments to keep semiconductor technology scaling possible has led industry and academia to search for alternatives to continue Moore’s law. As an alternative, 3-dimensional integrated circuits (3D ICs) have major advantages of smaller footprint, faster operation and/or low power consumption, and higher level of integration. These advantages can be further exploited with...
متن کاملAnalysis and Optimization of Accumulation-Mode Varactor for RF ICs
| This paper presents a novel RF IC varactor implemented in standard CMOS process. This device has shown a remarkable tuning range of 150%, sensitivity of 300%/V, and quality factor of 23 at 1 GHz. A physical model of the varactor is presented and con rmed with measured data. Using the model derived, optimization has shown that a Q as high as 200 can be achieved.
متن کاملPackaging Design with Thermal Analysis of LED on Silicon Substrate
In this paper, we demonstrate a package method for a package component of LED (Light Emitting Diode) using state of the art MEMS technologies and careful materials selection such as using a silicon substrate to dissipate heat and match thermal expansion coefficient (CTE). The objective is to develop an LED package that can overcome LED life, high operating voltage, package degradation and the a...
متن کاملLED Driver Lifetime and Reliability
While LEDs themselves are extremely reliable and have a long lifetime, are electronic LED drivers capable of providing the required current/voltage input to the LEDs over their whole lifetime? This paper aims to address the above question in general and for the Xitanium family of LED drivers developed by Philips Lighting specifically. It will describe some of the strategies which Philips applie...
متن کاملTest-Architecture Optimization for 3D Stacked ICs
TSV-based 3D-SICs significantly impact core-based systemon-chip (SOC) design. Testing of core-based dies in 3D-SICs introduces new challenges [1], [2]. In order to test the dies in a stack, the embedded cores, and the TSVs, a test access mechanism (TAM) must be included on the die to transport test data to the cores, and a 3D TAM is needed to transfer test data to the die from the stack input/o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions on Electrical and Electronic Materials
سال: 2017
ISSN: 1229-7607
DOI: 10.4313/teem.2017.18.2.59