Study on the weld bead formation on square-groove butt joint using plasma-MIG hybrid welding process
نویسندگان
چکیده
منابع مشابه
Effect of Mig Welding Input Process Parameters on Weld Bead Geometry on Hsla Steel
The various welding parameters such as welding speed, voltage and gas flow rate were varied on HSLA steel and the effects of these parameters on weld bead geometry such as penetration, width & height have been studied. Mathematical equations have been developed using factorial technique. And the result of various effects are shown in tables. (Numerical Values). INTRODUCTION Wide variety of stee...
متن کاملHybrid Laser-MIG welding: An investigation of geometrical considerations
This thesis presents a collection of theoretical and experimental investigations into various geometrical aspects of hybrid laser-MIG welding. The work is divided up into four parts; 1. A review of the hybrid laser-MIG welding technique with brief summaries of the three papers which make up the remainder of the thesis. 2. A paper entitled “Fundamental analysis of hybrid laser-MIG welding”. This...
متن کاملInfluence of the Activating Flux on Weld Joint Properties at Arc Stud Welding Process
The first papers on the activating flux application appeared already in 1950’s and 1960’s, but the interest for this welding process has been activated again in the last ten years 1, 2 . In order to increase the efficiency and productivity of TIG process, a variant of process with the activating flux is applied (ATIG). With the presence of the activating flux and high temperature, the value of ...
متن کاملPrediction of the Effect of Submerged Arc Welding Process Parameters on Weld Bead Width for MS 1018 Steel
The present investigation uses arc voltages, current, welding speed, wires feed rate and nozzle-to-plate distance as process parameters. Two level full factorial a technique has been used for experiment design. Multiple regression analysis has been used to develop a mathematical model to predict weld width using a single wire Submerged arc welding depositing bead-on-plate welds on 12mm plate. A...
متن کاملThe Effect of EN Ratio and Current on Microstructural and Mechanical Properties of Weld Joined by AC-GMAW on Square Groove Butt Joints
In the present work, the effect of welding current and electrode negative (EN) ratio on microstructure and mechanical properties of square groove butt joint produced by alternating current gas metal arc welding (AC-GMAW) process has been investigated. The experiments were conducted using different combination of welding current ranging from 150 A to 250 A with three distinct EN ratios i.e., 0%,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
سال: 2020
ISSN: 0288-4771,2434-8252
DOI: 10.2207/qjjws.38.135s