Study on the Bending Capacity of Cold-formed Stainless Steel Hollow Sections
نویسندگان
چکیده
منابع مشابه
Structural behavior of cold-formed stainless steel bolted connections
This paper presents a series of tests on cold-formed stainless steel bolted connections. The test specimens were fabricated from three different types of stainless steel, including austenitic stainless steel EN1.4301 (AISI 304) and EN1.4571 (AISI 316Ti having small amount of titanium) as well as lean duplex stainless steel EN1.4162 (AISI S32101). The material properties of the three types of st...
متن کاملSimulation of conventional cold-formed steel sections formed from Advanced High Strength Steel (AHSS)
The objective of this paper is to explore the potential impact of the use of advanced high strength steel (AHSS) to form traditional cold-formed steel structural members. In this study, shell finite element models are constructed, and geometric and material nonlinear collapse analysis performed, on simulated lipped channel cross-section cold-formed steel members roll-formed from AHSS. AHSS shee...
متن کاملComparative Study on Distortional Buckling Strength of Cold-Formed Steel Lipped Channel Sections
Usage of cold formed steel structural components for buildings and structures is gaining popularity in India for a decade. Hot rolled steel member behaviour and design are well developed, whereas the cold formed steel member behaviour and design is not developed fully compared to the rest of the world. The Indian code for cold-formed steel design, IS 801 was revised during 1975, which is in lin...
متن کاملOn Cold-Formed Steel Construction
Powder-actuated (also referred to as low velocity or powder-driven) fasteners are commonly used to attach cold-formed steel framing members, usually a track, to a concrete or structural steel support. Although commonly used, their behavior is less well understood than other fasteners such as screws, bolts and welds. The AISI Cold-Formed Steel Design Manual does not explicitly address powder act...
متن کاملBending Fatigue Tests and Finite Element Models of Steel Rectangular Hollow Sections [SRHS]
The Welding in cold formed areas is not only an open question for statically loaded sections (brittle fracture) but also for dynamically loaded structures (fatigue resistance). A lot of structures are subjected to dynamic loadings and unfortunately very little information about the influence of welding in the cold formed areas on fatigue resistance is available. In order to establish the fatigu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Structures
سال: 2016
ISSN: 2352-0124
DOI: 10.1016/j.istruc.2016.08.007