STUDY ON SOFTENING AND DROPPING PROPERTIES OF METALIZED BURDEN INSIDE BLAST FURNACE
نویسندگان
چکیده
منابع مشابه
Development of Blast Furnace Burden Distribution Process Modeling and Control
1) School of Automation and Electrical Engineering, University of Science and Technology Beijing, Beijing, 100083 China. 2) Key Laboratory of Advanced Control of Iron and Steel Process (Ministry of Education), University of Science and Technology Beijing, Beijing, 100083 China. 3) Department of Electrical & Computer Engineering, Missouri University of Science and Technology, Rolla, MO, 65409-00...
متن کاملDevelopment of an Online Blast Furnace Burden Profile Measuring System
Gas permeability in a blast furnace is directly influenced by the burden profile, which is the result of the charging angle collocation. An obviously increment in both iron-making productivity and furnace campaign life will be observed in a high heat utilization furnace with uniform gas permeability. An online burden profile measuring device without gas leakage risks and heavy maintaining load ...
متن کاملThe Study of Ion Adsorption by Amorphous Blast Furnace Slag
In this study, the blast furnace slag was used as absorbing bed and then, its ionic adsorption was studied. For this reason, various experimental parameters such as pH, contact time and the primary ion concentration were investigated. The remaining concentrations of ions such as; Mn2+ and Fe2+ in water were measured by atomic adsorption spectroscopy. The chemical and p...
متن کاملextraction and acetylation of purified trypsin from bovin pancreas and study of some its physico-chemical properties
آنزیم تریپسین در شرایط قلیایی ناپایدار می باشد .و فعالیت پروتئولیتیکی تریپسین منجربه خود هضمی آن در جایگاههای خاصی می گردد. بنابر این آنزیمی با ناپایداری بالا محسوب میگردد. در سالهای اخیر موفق شدند که با ایجاد تغیرات شیمیایی با اضافه کردن فلزات خاص ، کلسیم و یا عمل استیلاسیون منجر به افزایش پایداری آنزیم تریپسین گردند. مطالعات در حال حاضر نشان می دهد که تریپسین استیله شده فعالیت آنزیمی خود را ...
15 صفحه اولProperties of Foamed Mortar Prepared with Granulated Blast-Furnace Slag
Foamed mortar with a density of 1300 kg/m³ was prepared. In the initial laboratory trials, water-to-cement (w/c) ratios ranging from 0.54 to 0.64 were tested to determine the optimal value for foamed mortar corresponding to the highest compressive strength without compromising its fresh state properties. With the obtained optimal w/c ratio of 0.56, two types of foamed mortar were prepared, name...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tecnologia em Metalurgia Materiais e Mineração
سال: 2014
ISSN: 2176-1515
DOI: 10.4322/tmm.2014.051