Study on Pulse Current MIG Welding of Aluminium Alloys
نویسندگان
چکیده
منابع مشابه
Zinc-Nickel Binary Alloys Electrodeposition of Steel Using Pulse Current
Zinc-Nickel electrodeposits have been widely adopted for surface treatment of automobile steel sheet for high corrosion resistance. In this work the effect of pulse parameters on the Zn-Ni alloy electrodeposits was investigated. The hardness, thickness, corrosion resistance and composition of deposits thus produced were investigated. The surface topography of the deposits was also observed in S...
متن کاملZinc-Nickel Binary Alloys Electrodeposition of Steel Using Pulse Current
Zinc-Nickel electrodeposits have been widely adopted for surface treatment of automobile steel sheet for high corrosion resistance. In this work the effect of pulse parameters on the Zn-Ni alloy electrodeposits was investigated. The hardness, thickness, corrosion resistance and composition of deposits thus produced were investigated. The surface topography of the deposits was also observed in S...
متن کاملLaser welding of dissimilar aluminium alloys with filler material
Laser welding of dissimilar aluminium alloys with filler material Luís Filipe Amaro Pinto Instituto Superior Técnico – Technical University of Lisbon – Portugal September 2008 Abstract The aluminium alloys are materials with great potential because of its high strength and low weight. However, the welding of dissimilar aluminium alloys is difficult in autogeneous welding, due to these alloys ar...
متن کاملProblems in Welding of High Strength Aluminium Alloys
The 7XXX series alloys are heat-treatable Al-Zn-Mg or Al-Zn-Mg-Cu alloys. They develop their strength by solution heat treatment followed by ageing. In contrast to the 5XXX series alloys, the 7XXX series alloys do not respond favourably to cold work, because they are strengthened almost exclusively by GP zone formation and precipitates which nucleate from the GP zones. Introducing many new disl...
متن کاملStudy of Mechanical Properties Change During Friction Stir Spot Welding of Aluminium Alloys
The Friction Stir Welding process is now 20 years old and the interest in it and its potential continues to increase dramatically. FSW can be applied to a multitude of products with varying material types and thicknesses. However, a continuous weld is not always required to meet the product performance requirements. Thus, one can consider some form of intermittent weld, such as Friction Stir Sp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1981
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.50.201