Study on Mode III Fracture Toughness Testing Method using Uniaxial Testing Machine.
نویسندگان
چکیده
منابع مشابه
Prediction of Mode II of Fracture Toughness in Laminate Composites
In this paper, effects of ply orientation of adjacent plies with (ϕ//θ) interfaces on mode II critical strain energy release rate (fracture toughness) of multidirectional (MD) laminate has been studied. Ply orientation of adjacent plies is one of the most important parameters affects the mode II critical strain energy release rate () in the initiation of the delamination. To study this paramet...
متن کاملEffect of Rock Fracture Filling on Mode I and II Fracture Toughness
This paper focuses on some fracture toughness tests performed on the pre-cracked Brazilian specimens of rock-like materials. Also the effect of rock fracture filling on the fracture toughness was considered experimentally. Fracture toughness is a key parameter for studying the crack propagation and fragmentation processes in rock structures. Fracture mechanics is an applicable tool to improve ...
متن کاملComparison of two fracture toughness testing methods using a glass-infiltrated and a zirconia dental ceramic
PURPOSE The objective of this study was to compare the fracture toughness (KIc) obtained from the single edge V-notched beam (SEVNB) and the fractographic analysis (FTA) of a glass-infiltrated and a zirconia ceramic. MATERIALS AND METHODS For each material, ten bar-shaped specimens were prepared for the SEVNB method (3 mm × 4 mm × 25 mm) and the FTA method (2 mm × 4 mm × 25 mm). The starter V...
متن کاملNUREG/CR-6342 "Fracture Toughness Testing with Cracked Round Bars: Feasiblity Study"
SRI International has investigated the feasibility of measuring representative toughness values for nuclear pressure vessel materials using small cracked round bars (CRBs). We tested a weldment material [Heavy-Section Steel Irradiation (HSSI) Weld 72W with 0.23% copper] at six temperatures (-150%, -800, -500, 00, 230, and 50'C) using CRBs and compared the fracture-toughness results with data ob...
متن کاملFracture Toughness Study on Bulk Metallic Glasses and Novel Joining Method Using Bulk Metallic Glass Solder
The fracture toughness of three new compositional variants of the Zr-Ti-Be-LTM (Late Transition Metal) family of bulk metallic glasses (BMG’s) are studied in the as-cast and annealed condition. Quaternary Zr-Ti-Cu-Be alloys consistently had linear elastic fracture toughness values greater than 80 MPa·m, while Vitreloy 1, a Zr-Ti-Cu-Ni-Be alloy, had an average fracture toughness of 48.5 MPa·m wi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 2000
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.66.131