Study on Micro-EDM. (3rd Report). Fabrication of Micro-mecancial Elements.
نویسندگان
چکیده
منابع مشابه
MICRO-EDM FOR MICRO-CHANNEL FABRICATION ON NONCONDUCTIVE ZrO2 CERAMIC
In this study, microelectro-discharge (micro-ED) milling of nonconductive ZrO2ceramicsis investigated using a Cu tool electrode in kerosene dielectric. An adhesive Cu foil is firmly attached on the workpiece to initiate the sparks. After the machining of Cu foil, an electrically conductive carbonic layer is formed on the ceramic workpiece disassociating the kerosene dielectric, which allows mic...
متن کاملA Review of Micro - EDM
There is a huge demand in the production of microstructures by a non-traditional method which is known as Micro-EDM. Micro-EDM process is based on the thermoelectric energy between the workpiece and an electrode. Micro-EDM is a newly developed method to produce micro-parts which in the range of 50 μm -100 μm. Micro-EDM is an efficient machining process for the fabrication of a micro-metal hole ...
متن کاملMicro-layered-photolithography for Micro- Fabrication and Micro-molding
A novel process based on the principle of layered photolithography has been proposed and tested for making three-dimensional micro-structures. An experimental setup was designed and built for doing experiments on this micro-fabrication process. An ultraviolet (UV) excimer laser at the wavelength of 248 nm was used as the light source and a single piece of photo-mask carrying a series of two dim...
متن کاملFabrication of Polymeric Micro needle Array by Micromachining & Micro molding
Microneedles are expected to have greater demand in biomedical applications like sensing, electroporation & drug delivery in the future and there is need for development of fabrication process which is simple, economical and productive. Present work discusses about fabrication of PDMS (polydimethylsiloxane) micro needle array electrode for bio-potential signal measurement like EEG by micromachi...
متن کاملNozzle Fabrication for Micro Propulsion of a Micro Satellite
⎯ To enable formation flying of micro satellites, small sized propulsion systems are required. Our research focuses on the miniaturization of a feeding and thruster system by means of micro system technology (MST). Three fabrication methods have been investigated to make a conical converging-diverging nozzle. These methods are reactive ion etching, femtosecond laser machining (FLM) and a combin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Japan Society of Electrical Machining Engineers
سال: 1994
ISSN: 1881-0888,0387-754X
DOI: 10.2526/jseme.28.59_1