Study on Mechanical Properties of Steel Fiber Rubber Recycled Brick Concrete
نویسندگان
چکیده
In order to study the mechanical properties of steel fiber rubber recycled brick concrete, ten groups concrete specimens with strength 15MPa were tested , one group was purely remaining nine mixed different rations admixture. Three fiber, another three granules, last both and granules. These by pressure testing machine respectively, maximum is calculated its stress value. The results proved that: when adding can improve higher percentage added, more obvious increases in strength. granules showed a reduced significant drop When added same result an increased as two kinds admixture dosage simultaneously, rapidly.
منابع مشابه
Basic Mechanical Properties of Basalt Fiber Reinforced Recycled Aggregate Concrete
In order to study the basic mechanical properties of basalt fiber reinforced recycled aggregate concrete, the concrete mix ratio, the length and the volume mixing ratio of chopped basalt fiber yarn are designed for changing factors. A total of 324 specimens have been completed for this investigation. The compressive strength, splitting tensile strength, elastic modulus and axial compressive str...
متن کاملخواص بتن با استفاده از لاستیک های ضایعاتی concrete properties containing recycled rubber waste
چکیده ندارد.
15 صفحه اولEffectiveness of Fiber Reinforcement on the Mechanical Properties and Shrinkage Cracking of Recycled Fine Aggregate Concrete
This paper presents an experimental study conducted to investigate the effect of fiber reinforcement on the mechanical properties and shrinkage cracking of recycled fine aggregate concrete (RFAC) with two types of fiber-polyvinyl alcohol (PVA) and nylon. A small fiber volume fraction, such as 0.05% or 0.1%, in RFAC with polyvinyl alcohol or nylon fibers was used for optimum efficiency in minimu...
متن کاملMechanical Properties of Recycled Concrete in Marine Environment
Experimental work was carried out to develop information about mechanical properties of recycled concrete (RC) in marine environment. By using the seawater and dry-wet circulation to simulate the marine environment, specimens of RC were tested with different replacement percentages of 0%, 30%, and 60% after immersing in seawater for 4, 8, 12, and 16 months, respectively. Based on the analysis o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: E3S web of conferences
سال: 2021
ISSN: ['2555-0403', '2267-1242']
DOI: https://doi.org/10.1051/e3sconf/202123303011