Study on Manufacturing Micro Axial-flow Pump
نویسندگان
چکیده
منابع مشابه
Manufacturing Process Flow Reasoning of Micro Device Based on Ontology
Based on feature modeling technology, a method of manufacturing process flow reasoning of micro device is presented to support the top-down design flow. The knowledge of micro device is hierarchically organized to construct the ontology-based knowledge database that is combined with the expert system by an interface. With the support of process databases, the manufacturing process flow is deriv...
متن کاملA Compact Magnetic Bearing System for Axial Flow Blood Pump
In this paper, a compact magnetic bearing system has been developed for axial flow blood pumps. The system is composed of two radial hybrid magnetic bearings (HMBs) and a brushless permanent magnet DC motor. The impeller of the pump is enclosed in the rotor that is suspended by the two HMBs with five-degree of freedom (DOF) control, among which four radial directions are actively controlled, an...
متن کاملAn electro-osmotic micro-pump based on monolithic silica for micro-flow analyses and electro-sprays.
A high-pressure electro-osmotic micro-pump fabricated by a sol-gel process is reported as a fluid-driving unit in a flow-injection analysis (FIA) system. The micro FIA system consists of a monolithic micro-pump on a glass slide (2.5 x 7.5 cm), a micro-injector, and a micro-sensor (2.5 x 1.5 cm). The monolithic silica matrix has a continuous skeleton morphology with micrometer-sized through-pore...
متن کاملAdvanced heart failure: feasibility study of long-term continuous axial flow pump support.
AIMS A lack of donor hearts has stimulated interest in using blood pumps to treat severe heart failure. We tested the hypothesis that a new continuous flow circulatory assist device could be employed safely to relieve symptoms of heart failure and evaluated the potential to prolong life. METHODS AND RESULTS An intracardiac axial flow pump was implanted in 17 heart failure patients [idiopathic...
متن کاملNumerical Simulation of Air-Water Bubbly Flow in Axial Flow Pump Impeller
In this paper, the lift-law method was applied to design the axial flow pump. Based on Reynolds time-averaged N-S equations and standard k turbulent model, three-dimensional air-water bubbly flow in an axial flow pump impeller was simulated. Under the condition of bubble void fraction of 5%, pressure and void fraction distributions were respectively obtained, movement of bubbles in the impeller...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 2007
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.73.112