Study on machining of GFRP by low frequency vibration cutting
نویسندگان
چکیده
منابع مشابه
a study on the effectiveness of task types (noticing-reformulation) on iranian low intermediate efl learners’ retention of collocations
چکیده پژوهش شبه تجربی حاضر به بررسی بکارگیری تمارین کلاسی که برانگیزنده آگاهی و توجه آگاهانه به همایندها بعنوان بخشی از یک دوره ی مکالمه زبان خارجی در یکی از آموزشگاه های زبان انگلیسی ایران است می پردازد.
a study on insurer solvency by panel data model: the case of iranian insurance market
the aim of this thesis is an approach for assessing insurer’s solvency for iranian insurance companies. we use of economic data with both time series and cross-sectional variation, thus by using the panel data model will survey the insurer solvency.
Performance of Air Foam Flooding under Low Frequency Vibration
Foam injection is widely applied in amounts of fields to drilling, production, and formation protection. Sometimes, the application result is disappointing, which is caused by the failure of bubble generation in foam flooding. Therefore, it is necessary to seek ways for improving the performance of foam injection. An increased disturbance to the stratum, like the vibration caused by a seismic o...
متن کاملMeasurement and Analysis of Low Frequency Vibration
Low frequency vibration occurs especially in ground transportation, either as a cause in adjacent environment or within the vehicle itself. The piezoelectric accelerometers commonly used for vibration measurement are not suitable, hence other sensors capable of measuring accelerations down to sub-hertz region have to be used. Based on some previous experience with MEMS acceleration sensors a th...
متن کاملEffect of low-frequency vibration on workpiece in EDM processes
High-frequency vibration aided EDM has become one of the ways to increase material removal rate in EDM process, due to the flushing effect caused by vibration. However, utilizing high-frequency vibration, especially in ultrasonic range consumes a lot of setup cost. This work presents an attempt to use a low-frequency vibration on workpiece of stainless steel (SS 304) during EDM process. The wor...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Seikei-Kakou
سال: 1991
ISSN: 1883-7417,0915-4027
DOI: 10.4325/seikeikakou.3.81