Study on Creep Damage Assessment Method for Mod. 9Cr-1Mo Steel by Sampling Creep Testing with Thin Plate Specimen
نویسندگان
چکیده
منابع مشابه
An Inverse Approach for Determining Creep Properties from a Miniature Thin Plate Specimen under Bending
This paper describes a new approach which can be used to interpret the experimental creep deformation data obtained from miniaturized thin plate bending specimen test to the corresponding uniaxial data based on an inversed application of the reference stress method. The geometry of the thin plate is fully defined by the span of the support, l, the width, b, and the thickness, d. Firstly, analyt...
متن کاملLecture 14 : Creep – Resistant Steel , Case Study
Introduction Typical operating parameters for steels used in the manufacture of power plant are compared against corresponding values for nickel alloys in aeroengines, in Table 1. In both cases, the service conditions are severe. But this is especially so for steels where the service life is many decades. The degree of reliability demanded of heat resistant steels is therefore extraordinary, an...
متن کاملA method of specimen corrosion protection for high temperature creep testing
-The determination of mechanical properties of materials at elevated temperatu~; presents difficulties, particularly when the material to be tested is subject to oxidation. Various methods have been employed to permit the evaluation of high temperature creep properties. The method described in this paper was developed on the basis of modifications of a technique developed for the protection of ...
متن کاملStudy of cavities in a creep crack growth test specimen
During their operation, modern aircraft engine components are subjected to increasingly demanding operating conditions, especially the high pressure turbine (HPT) blades. Such conditions cause these parts to undergo different types of time-dependent degradation, one of which is creep. A model using the finite element method (FEM) was developed, in order to be able to predict the creep behaviour...
متن کاملInfluence of Coincidence Site Lattice Boundary on Creep Resistance of P91 Steel Weldments
The grain boundary structure is usually described by the coincidence site lattice (CSL) model based on the misorientation of adjoining crystals. Therefore, the objective of the present investigation is to seek the correlation between CSL fraction and creep resistance of modified 9Cr–1Mo steel (P91) with and without boron addition. Results showed that CSL fraction increases with increase in heat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2019
ISSN: 0514-5163,1880-7488
DOI: 10.2472/jsms.68.421