Study of Sintered Aluminum Foil-powder Alumnite Catalyst
نویسندگان
چکیده
منابع مشابه
Reduction of Surface hr~ >ion Caused by Helium Blistering in Sintered Beryllium and Sintered Aluminum Powder
Studies have been conducted to find Materials with microstructures which Minimize the formation of blisters. A promising class of materials appears to be sintered metal powder with small average grain sizes and low atomic number Z. Studies of the surface erosion of sintered aluminum powder (SAP 895) and of aluminum held at AOO'C due to blistering by 100 keV helium ions have been conducted and t...
متن کاملShielding a room using aluminum foil
A local hospital was interested in shielding some sensitive equipment and contemplated installing a shielded room. The room under consideration was the typical laminated wood core panel with galvanized steel on both surfaces, with a RF shielded door, honeycomb air vent panels and filters for ac power, telephone and any other signals, meeting the shielding effectiveness requirements of MIL-STD-2...
متن کاملMetal functionalization of carbon nanotubes for enhanced sintered powder wicks
Phase change cooling schemes involving passive heat spreading devices, such as heat pipes and vapor chambers, are widely adopted for thermal management of high heat-flux technologies. In this study, carbon nanotubes (CNTs) are fabricated on a 200 lm thick sintered copper powder wick layer using microwave plasma enhanced chemical vapor deposition technique. A physical vapor deposition process is...
متن کاملCharacterization of loose powder sintered porous titanium and Ti6Al4V alloy
Porous titanium and Ti6Al4V alloy, biomedical candidate materials for use in orthopedic and dental implants, were manufactured by sintering the powders at various temperatures in loose condition. The characteristics of the corresponding powders and utilized sintering temperatures limited the final porosities in the range 30-37.5 vol. %. Similar to wrought alloys, compression stress-strain curve...
متن کاملDecomposition of Cyclohexane on Ni3Al Thin Foil Intermetallic Catalyst
Micro-grained thin foils made of Ni₃Al intermetallic alloy were fabricated, according to a previously described procedure, and tested as catalyst for decomposition of cyclohexane. The conversion efficiency of the catalyst was evaluated in a synthetic air atmosphere, and found to be as high as 98.7% ± 1.0% at 600 °C and 86.7% ± 3.6% at 500 °C. During the reaction, the growth of carbon nanofibers...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Sciences
سال: 2010
ISSN: 1812-5654
DOI: 10.3923/jas.2010.3379.3383