Study of Process Parameters for Making Biodegradable Linear Low Density Polyethylene in Natural Weathering Conditions
نویسندگان
چکیده
منابع مشابه
Preparation of Biodegradable Low Density Polyethylene by Starch – Urea Composition for Agricultural Applications
It has been proven that polyolefins specially low density polyethylene (LDPE), are resistant against degradation and microorganism attacks; Thus, one of the most important properties of industrial plastics, is their environmental biodegradability. Since plastics are being widely used in agriculture, horticulture and packaging, meeting this requirement becomes increasingly dificult (speciall...
متن کاملTensile and Physical Properties of Linear Low Density Polyethylene-natural Rubber Composite: Comparison between Size and Filler Types
Linear Low Density Polyethylene-Natural Rubber (LLDPE-NR) composites in the ratio of 70:20 were made with different loadings of nanosilica and micro-scale Palm Oil Fuel Ash (POFA). Linear Low Density Polyethylene grafted with maleic anhydride (LLDPE-g-MAH) of 10 wt% was added as a compatibiliser. The composites were produced by using two-roll mill machine. The tensile properties of the composit...
متن کاملpreparation of biodegradable low density polyethylene by starch – urea composition for agricultural applications
it has been proven that polyolefins specially low density polyethylene (ldpe), are resistant against degradation and microorganism attacks; thus, one of the most important properties of industrial plastics, is their environmental biodegradability. since plastics are being widely used in agriculture, horticulture and packaging, meeting this requirement becomes increasingly dificult (specially in...
متن کاملOptimization of Injection Moulding Process Parameters in the Moulding of Low Density Polyethylene (LDPE)
Injection moulding is one of the most popular polymer processing methods due to its high production rate as well as its ability to produce very intricate geometries at very cheaper cost and within few seconds. There are several flaws which occur while producing plastic parts by Injection moulding, like warpage, shrinkage, flash, sink marks etc. Shrinkage is one of the most critical problems whi...
متن کاملEvaluation of continuous and discrete melting endotherms in determination of structural heterogeneities in Ziegler-Natta catalyzed linear low density polyethylene
Ethylene / 1-butene copolymers at different comonomer levels were synthesized using Ziegler-Natta catalyst to evaluate the applicability of thermal fractionation methods in predicting chemical composition distribution (CCD). The continuous melting endotherms by DSC were converted to continuous CCD, and the average comonomer contents were compared with NMR results. DSC underestimated comonomer c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOSR Journal of Applied Chemistry
سال: 2017
ISSN: 2278-5736,2278-5736
DOI: 10.9790/5736-1005027990