Study of Injection Molding Process of Shift Lever Using Injection Molding Analysis
نویسندگان
چکیده
منابع مشابه
Precision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملOptimization of the injection molding process of Derlin 500 composite using ANOVA and grey relational analysis
Warpage and shrinkage control are important factors in proving the quality of thin-wall parts in injection modeling process. In the present paper, grey relational analysis was used in order to optimize these two parameters in manufacturing plastic bush of articulated garden tractor. The material used in the plastic bush is Derlin 500. The input parameters in the process were selected according ...
متن کاملFinding efficient frontier of process parameters for plastic injection molding
Product quality for plastic injection molding process is highly related with the settings for its process parameters. Additionally, the product quality is not simply based on a single quality index, but multiple interrelated quality indices. To find the settings for the process parameters such that the multiple quality indices can be simultaneously optimized is becoming a research issue and ...
متن کاملCeramic Injection Molding
Powder injection molding (PIM), which encompasses metal injection molding (MIM) and ceramic injection molding (CIM), is a net-shaping process which enables large scale production of complex-shaped components for use in a diverse range of industries. It combines plastic injection molding techniques and performance attributes of ceramic and metal powders. Ceramic injection molding (CIM) uses cera...
متن کاملStability analysis of injection molding flows
We numerically investigate the stability problem of the injection molding process. It was indicated by Bulters and Schepens Bulters and Schepens 2000 that surface defects of injection molded products may be attributed to a flow instability near the free surface during the filling stage of the mold. We examine the stability of this flow using the extended Pom–Pom constitutive equations. The mode...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean Society of Manufacturing Process Engineers
سال: 2015
ISSN: 1598-6721
DOI: 10.14775/ksmpe.2015.14.6.007