Study of Heat Rejection Mechanism of a Direct-injection Diesel Engine. 2nd Report. Effects of Combustion Control Item on Heat Flux.
نویسندگان
چکیده
منابع مشابه
Effects of Direct Water Injection on DI Diesel Engine Combustion
The effects of in-cylinder water injection on a direct injection (DI) Diesel engine were studied using a computational fluid dynamics (CFD) program based on the Kiva-3v code. The spray model is validated against experimental bomb data with good agreement for vapor penetration as a function of time. It was found that liquid penetration increased approximately 35% with 23% of the fuel volume repl...
متن کاملThree-Dimensional Modeling of Combustion Process, Soot and NOx formation In a Direct-injection Diesel Engine
This paper is presented to study the combustion process and emissions in a direct injection diesel engine. Computations are carried out using a three-dimensional model for flows, sprays, combustion and emissions in Diesel engines. Interactions between combustion and emissions with flow field are considered and it is shown that soot mass fraction increases at regions with low turbulence inten...
متن کاملPerformance evaluation of a low heat rejection diesel engine with carbureted ethanol and jatropha oil
Experiments were conducted to evaluate the performance of a low heat rejection (LHR) diesel engine. Performance parameters and emission levels were determined at various magnitudes of brake mean effective pressure. Combustion characteristics of the engine were measured with TDC (top dead centre) encoder, pressure transducer, console and special pressure-crank angle software package at peak load...
متن کاملPerformance evaluation of waste fried vegetable oil in a medium grade low heat rejection diesel engine
Investigations were carried out to evaluate the performance of direct injection diesel engine with medium grade low heat rejection (LHR) combustion chamber and 3 mm air gap insulated piston, 3 mm air gap insulated liner, and ceramic coated cylinder head [ceramic coating with the thickness of 500 µ was made on the inside portion of the cylinder head].The engine had different operating conditions...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1997
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.63.3194