Study of Hard Milling Surfaces Via Nondestructive Magnetic Method
نویسندگان
چکیده
منابع مشابه
Preparation of Fe3O4@SiO2 Nanostructures via Inverse Micelle Method and Study of Their Magnetic Properties for Biological Applications
In this work, we report synthesis of superparamagnetic iron oxide nanoparticles at room temperature using microemulsion template phase consisting of cyclohexane, water, cetyltrimethylammonium bromide CTAB as cationic surfactant and butanol as a cosurfactant. Silica surface modification of the as prepared nanoparticles was performed by adding tetraethoxysilane TEOS to alkaline medium. The struct...
متن کاملPreparation of Fe3O4@SiO2 Nanostructures via Inverse Micelle Method and Study of Their Magnetic Properties for Biological Applications
In this work, we report synthesis of superparamagnetic iron oxide nanoparticles at room temperature using microemulsion template phase consisting of cyclohexane, water, cetyltrimethylammonium bromide CTAB as cationic surfactant and butanol as a cosurfactant. Silica surface modification of the as prepared nanoparticles was performed by adding tetraethoxysilane TEOS to alkaline medium. The struct...
متن کامل5-Axis Flank Milling of Sculptured Surfaces
This chapter covers the various free-form surface flank milling strategies available, focusing in particular on those for ruled surfaces as widely used in defining turbomachine parts. All these positionings seek to reduce interference between the cutting tool and the surface to be milled so as to respect the tolerances dictated by the Design Office. The range of strategies presented goes from t...
متن کاملTriple tangent flank milling of ruled surfaces
This paper presents a positioning strategy for flank milling ruled surfaces. It is a modification of a positioning method developed by Bedi et al. [1]. A cylindrical cutting tool is initially positioned tangential to the two boundary curves on a ruled surface. Optimization is used to move these tangential points to different curves on the ruled surface to reduce the error. A second optimization...
متن کاملInvestigation the Milling Strategies Effects on Machining of Convex Surfaces made of Glass/Epoxy Composite
In this study the effects of machining parameters such as shearing speed, feed rate, tool diameter and machining depth on different milling strategies i.e. 3D offset, spiral, raster and radial to produce the convex surface made of epoxy/glass composites is investigated. The effects of mentioned strategies on output parameters such as surface roughness and milling removal rate is also studied. T...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Technological Engineering
سال: 2016
ISSN: 1336-5967,2451-3156
DOI: 10.2478/teen-2016-0012