Study of EB Resist Simulation for EUV Resist Evaluation
نویسندگان
چکیده
منابع مشابه
Report on EUV resist and process limitations
EUV lithography (λ=13.4nm) has been identified as one of the technologies likely to succeed to 193nm lithography for the definition of ever-smaller transistor architectures. Whether EUV in the end will outrank competing technologies for the 32nm and 22nm nodes (Hyper NA immersion, maskless, nanoimprint) and whether EUV will make it to mass production of integrated circuits will depend on both E...
متن کاملRecent Progress of EUV Resist Technology in EIDEC
EUV lithography is one of the promising technologies for manufacturing devices at 16 nm half-pitch node and below. EUV resists are required to improve the resolution, line width roughness (LWR), and sensitivity. However it is generally thought that the lithographic performance is determined by the trade-off relationship among these factors. Moreover, resist outgassing is another issue with EUV ...
متن کاملModeling of EUV photoresists with a resist point spread function
Extreme ultraviolet (EUV) lithography is under development for possible deployment at the 32-nm technology node. One active area of research in this field is the development of photoresists that can meet the stringent requirements (high resolution, high sensitivity, low LER, etc.) of lithography in this regime. In order to facilitate research in this and other areas related to EUV lithography, ...
متن کاملDependence of electron beam diameter, electron energy, resist thickness and resist type for forming nano-sized dot arrays in EB lithography by using Monte Carlo Simulation
We have calculated the electron energy deposition distribution in Calixarene negative resist and analyzed the development profile in order to improve the resolution of pattern. From the trajectories and energy deposition distribution in resist at various beam diameters, it is obvious that the thinner resist film should be adopted for formation of very fine dots. The analysis of relationship bet...
متن کاملResist evaluation for Ni mold fabrication and proton beam writing
In our experiments, we use different photoresists for proton beam writing and mold fabrication. We have fabricated Ni mold with structures down to 500 nm. We first use a fine focused proton beam to expose different photoresists, Polymethyl Methacrylate (PMMA), AR-P 3250 and ma-N 2410. After development and nickel sulfamate electroplating, the structures were faithfully transferred from the phot...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Photopolymer Science and Technology
سال: 2020
ISSN: 0914-9244,1349-6336
DOI: 10.2494/photopolymer.33.221