Study at the Bolted Joint Assembly with Slotted Hole
نویسندگان
چکیده
منابع مشابه
Hole-Slotted Phased Array at 7 Tesla
Introduction The development of RF coils is always focused towards increasing SNR and optimizing the RF penetration into the sample. Multi channel receiver arrays have been shown to increase the SNR and/or the speed (if combined with parallel imaging) in clinical and animal MRI studies [1]. Array coils for high fields are usually based on simple loops and are mostly used in rat imaging studies ...
متن کاملBolted Connection Strength and Bolt Hole Size
This study investigated the effects of oversized bolt holes on the properties of bolted connections with steel side members. The intent of the study was to determine (1) how well the European Yield Model (EYM) predicts experimental results for connections with oversized bolt holes and (2) how the loaddeformation behavior of connections is affected by oversized and/or misdrilled holes. Variables...
متن کاملassembly performance of a gasketed bolted flanged pipe joint using different bolt tightening strategies
this paper presents the results of the assembly process of a gasketed bolted flanged pipe joint for two different bolt tightening strategies, i.e. asme and industrial using torque control of preload method. the final clamping force is achieved in four and five passes in asme and industrial strategy respectively. axial bolt stress variation, at the end of each pass, individual bolt bending beha...
متن کاملOverlap Decoupling in Hole-Slotted Arrays
Introduction Since the first phased array design, the overlap decoupling became the most often used decoupling technique. At a certain amount of overlap, the mutual inductance between adjacent array coil elements is forced to be zero. Therefore the interaction between neighbouring coil elements is eliminated [1]. The hole-slotted coil design has been shown to provide a deeper RF penetration int...
متن کاملEvaluation of Fatigue Life Reduction Factors at Bolt Hole in Double Lap Bolted Joints Using Volumetric Method
In this research, the influence of bolt preload on the fatigue strength of 2024-T3 aluminium alloy double lap bolted joints has been studied experimentally and numerically. To do so, three sets of the specimens were prepared and each of them subjected to tightening torque of 1,2.5 and 5 N-m and then fatigue tests were conducted under various cyclic axial load levels. In the numerical method, th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IPTEK Journal of Proceedings Series
سال: 2014
ISSN: 2354-6026
DOI: 10.12962/j23546026.y2014i1.426