Studies on Turning of Carbon/Phenolic Ablative Composite Using PCBN Tools

Hard turning with variable micro-geometry PcBN tools

This paper presents investigations on hard turning with variable edge design PcBN inserts. Turning of hardened AISI 4340 steel with uniform and variable edge design PcBN inserts is conducted, forces and tool wear are measured. 3D finite element modelling is utilized to predict chip formation, forces, temperatures and tool wear on uniform and variable edge micro-geometry tools. Predicted forces ...

Process simulations for 3D turning using uniform and variable microgeometry PCBN tools

In this paper, uniform and variable edge microgeometry design inserts are utilised and tested for 3D turning process. In 3D tool engagement with workpiece, thickness of the chip varies from a maximum equal to the feed rate (at primary cutting edge) to a minimum on the tool’s corner radius (at trailing cutting edge). The ideal tool edge preparation should posses a variable configuration which ha...

buckling of viscoelastic composite plates using the finite strip method

در سال های اخیر، تقاضای استفاده از تئوری خطی ویسکوالاستیسیته بیشتر شده است. با افزایش استفاده از کامپوزیت های پیشرفته در صنایع هوایی و همچنین استفاده روزافزون از مواد پلیمری، اهمیت روش های دقیق طراحی و تحلیل چنین ساختارهایی بیشتر شده است. این مواد جدید از خودشان رفتارهای مکانیکی ارائه می دهند که با تئوری های الاستیسیته و ویسکوزیته، نمی توان آن ها را توصیف کرد. این مواد، خواص ویسکوالاستیک دارند....

On machining of hardened AISI D2 steel with PCBN tools

This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...

Reducing Fracture Tendencies in PCBN FSW Tools