Studies on Slip Casting Control VI
نویسندگان
چکیده
منابع مشابه
Studies on Digitalis VI
T IS undisputed that the administration of digitalis to patients with many forms of congestive heart failure results in an improvement in both the clinical state and in the abnormal circulatory dynamics that are characteristic of heart failure.'-6 The effects of digitalis in subjects without heart failure are less well defined. Although some glycosides augment the contractile force of nonfailin...
متن کامل[Mechanical studies on casting titanium alloy denture base].
The mechanical properties of the Akers type clasp, bar and frame made by the newly developed Ti-20Cr-0.2Si alloy were studied in order to obtain the indices for designing the cast partial denture base. In the case of the clasp, the bending strength of the Ti-20Cr-0.2Si alloy and pure Ti was lower than that of the Co-Cr alloy. The Ti-20Cr-0.2Si alloy and pure Ti may have the same retentive force...
متن کاملControl issues in continuous casting of steel
Continuous casting plants are highly complex plants whose performance requires reliable mold level control system. Several effects greatly influence the surface quality of the final product and if these are not suppressed sufficiently by the mold level control system, than the production speed, hence the productivity has to be lowered. This paper analyses the most important disturbance and thei...
متن کاملDevelopment of nano-grained Calcium Hy-droxyapatite using slip casting technique
The purpose of this study is to synthesize nano-grained Calcium Hydroxyapatite (HAp) through slip casting technique. For this, hydroxyapatite powders were synthesized using two methods, wet chemical method and Ammoniacal method. The as-prepared powders and calcined powders were characterized using XRD, FTIR, to study the phases of the powders. The hydroxyapatite powder calcined at 1000°C for 2h...
متن کاملOn Liquid Metal Wetting of Casting Rings for DC Casting
During air–slip direct chill casting of aluminum alloys, uneven or low air pressure areas at the surface of the porous graphite ring mold, can cause the metal to stick to the graphite ring and produce traces along the billets called vertical drags (VD). To prevent this type of defect, it would be an advantage to decrease the wettability of the graphite ring. It has been shown that nanostructure...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Association, Japan
سال: 1972
ISSN: 0009-0255,1884-2127
DOI: 10.2109/jcersj1950.80.926_375