Studies on Sampling Points for Measurement of Dust Concentration in Horizontal Straight Flue

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Theoretical Optimization of Troposphere Ionization Exchange Points to Reduce the Concentration of Fine Dust in Ahvaz City, Iran

Aims: The dust crisis and the numerous problems caused by it, which have affected most of the Western and Southwestern regions of Iran in recent years, need an appropriate and cost-effective solution to improve living and respiratory conditions without adverse human or environmental effects. The purpose of this study was to analyze the location of injection technology equipment to reduce the co...

متن کامل

Decay of Rotational Airflow with Flow Conditioner in Larger Diameter Ducts for Dust Concentration Measurement using Isokinetic Sampling

Within this study the decay speed of centrifugal device induced rotational airflow in round ducts and its conditioning for dust concentration measurement was investigated. Tests were conducted under room conditions at average Reynolds numbers within the range of 0.7–1.14x10. Duct diameters were 152 mm and 203 mm. Airflow in the ducts was found nonuniform and unsteady within the axial location t...

متن کامل

Pressure Drop Characteristics of Bi-Modal Slurry at Medium Concentration in Straight Horizontal Pipes

In the present study, pressure drop have been measured for narrow sized silica sand slurry and bimodal slurry consisting of narrow sized silica sand and fly ash as fine particles in different proportions keeping the overall efflux concentration same using a pilot plant test loop. The pressure drop has been measured over a length of 4.0 m in 50 mm NB diameter pipe line for fully developed flow. ...

متن کامل

simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: The Journal of the Society of Chemical Industry, Japan

سال: 1969

ISSN: 0023-2734,2185-0860

DOI: 10.1246/nikkashi1898.72.11_2347