Studies on reinforcement by affixing metal plate. Part 1 Three point bending test.

Flexural Properties and Fracture Behavior of Nanoporous Alumina film by Three-Point Bending Test

This study investigated the influence of porosity on the flexural property of a nanoporous alumina film. When the porosity of the alumina film increased, both bending strength and modulus declined. The results from the bending test revealed that the setting of the film during the bending test had significant influence on the flexural property. Fracture only occurred when the porous side of the ...

Corrosion Fatigue Studies on a Bulk Glassy Zr-Based Alloy under Three-Point Bending

Corrosion fatigue (CF) tests were carried out on bulk glassy Zr52.5Cu17.9Al10Ni14.6Ti5 (Vitreloy 105) samples under load-controlled three-point bending conditions with a load ratio of R = 0.1 in 0.01 M Na2SO4 + 0.01 M NaCl electrolyte. During cyclic testing, the bar-shaped specimens were polarized in situ at constant potentials and the current was monitored. Three different anodic potentials wi...

Bamboo Taper Effect on Third Point Loading Bending Test

Abstract—Geometrical shape of bamboo usually assumed as tapered hollow pipe. This study proved that the dimensional changes along the bamboo stem significantly affected to its Modulus of Rupture (SR) value which measured from third point loading bending test. Therefore if the bending test applied using third point loading configuration, the SR value should be adjusted by strength ratio of taper...

On the extent of mantle hydration caused by plate bending

Optimized Bending Sequences of Sheet Metal Bending by Robot

In the present study, a method is proposed which generates bending sequences of a sheet metal part handled by a robot. If parts are handled by a robot, the best grasping positions for each bending and the number of repositions must be indicated in advance. Using the proposed method, feasible bending sequences with grasping positions are obtained and the sequences are sorted in order of the numb...